1.1.5. Check exhaust system for leaks.
Possible cause of fault
- Leaks
Possible remedy
- Check entire exhaust system for leaks.
1.1.6. Check signal from component B2/5 (Hot film mass air flow sensor) via actual value.
Test 1.1.6.1: Check signal of component B2/5 (Hot film mass air flow sensor) via actual value with engine OFF.
Test 1.1.6.2: Check signal of component B2/5 (Hot film mass air flow sensor) via actual value with engine speed greater than 3500 rpm.
Test 1.1.6.3: Check reference signal of component B2/5 (Hot film mass air flow sensor).
1.1.6.1. Check signal of component B2/5 (Hot film mass air flow sensor) via actual value with engine OFF.
Warning!Communication with ECU required.
1.1.6.2. Check signal of component B2/5 (Hot film mass air flow sensor) via actual value with engine speed greater than 3500 rpm.
Warning!Communication with ECU required.
1.1.6.3. Check reference signal of component B2/5 (Hot film mass air flow sensor).
Test sequence
- Switch on ignition.
Status of relevant actual value:
- HFM-SFI ( Reference signal ):Warning! Communication with ECU required.
Specified value
- Reference signal[46...59] ms
Question
- Is the measurement value OK?
YES
The actual value is okay.End of test
NO
The actual value is not o.k.Possible cause and remedy
- Check lines from component N3/10 (ME-SFI [ME] control unit) to component B2/5 (Hot film mass air flow sensor).
- B2/5 (Hot film mass air flow sensor)
1053
This fault can be ignored and erased.
Possible cause:
- This fault can be ignored and erased.
Affected functions:
- Engine diagnosis
-------------------------------------------------
Test 1: This fault can be ignored and erased.
1. This fault can be ignored and erased.
Note:This fault can be ignored and erased.
No comments:
Post a Comment