Monday, January 20, 2020

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1055

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1055



Component Testing



1. Ignition OFF, disconnect the harness connector at the B65 Intake Manifold Pressure and Air Temperature sensor.



Note: A thermometer can be used to test the sensor off the vehicle.



2. Test the IAT sensor by varying the sensor temperature while monitoring the sensor resistance. Compare the readings with the Temperature



Versus Resistance - Intake Air Temperature Sensor (See: Powertrain Management/Computers and Control



Systems/Specifications/Temperature Versus Resistance - Intake Air Temperature Sensor) table and verify that the resistance is within 5 % of



the specification.



瀚慖f not within the specified range, replace the B65 Intake Manifold Pressure and Air Temperature sensor.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Turbocharger Pressure Sensor Replacement (See: Powertrain Management/Fuel Delivery and Air Induction/Turbocharger/Service and



Repair/Turbocharger Pressure Sensor Replacement)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for engine control module replacement, setup, and



programming



P0112



DTC P0111-P0114 (LAU)



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P0111



- Intake Air Temperature (IAT) Sensor Circuit Performance



DTC P0112



- Intake Air Temperature (IAT) Sensor Circuit Low Voltage



DTC P0113



- Intake Air Temperature (IAT) Sensor Circuit High Voltage



DTC P0114



- Intake Air Temperature (IAT) Sensor Intermittent



Diagnostic Fault Information



Typical Scan Tool Data

No comments:

Post a Comment