Sunday, December 29, 2019

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1359

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1359



DTCs P0450 and P0451 are Type B DTCs.



Conditions for Clearing the MIL/DTC



DTCs P0450 and P0451 are Type B DTCs.



Diagnostic Aids



A blocked or clogged EVAP canister vent may set these DTCs.



Reference Information



Schematic Reference



Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls Schematics



(LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Evaporative Emission Control System Description (See: Powertrain Management/Computers and Control Systems/Description and



Operation/Evaporative Emission Control System Description)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



DTC Type Reference



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information



Special Tools



* J 41413-SPT High Intensity White Light



* J 41413-VLV EVAP Port Vent Fitting Tool



* J 41413-200 Evaporative Emissions System Tester (EEST)



* J 41413-300 EVAP Cap and Plug Kit



* CH-48096 EVAP Service Port Access Tool



* GE-41415-50 Fuel Tank Cap Adapter



Circuit/System Testing



1. Ignition OFF, remove the fuel fill cap. Connect the GE-41415-50 to the fuel tank filler neck. Connect the J 41413-200 to the GE-41415-50



.



2. Ignition ON, seal the system using the Purge Seal function with a scan tool.



3. Pressurize the EVAP system with nitrogen to 9.33 mm/Hg (5 in. H2O). Compare the scan tool Fuel Tank Pressure Sensor parameter to the J



41413-200 pressure/vacuum gauge. Verify the fuel tank pressure sensor parameter is within +/-0.9 mmHg (+/-0.5 in.H2O) of the



pressure/vacuum gauge.



瀚慖f not within the specified range, replace the B150 fuel tank pressure sensor.



4. Command the EVAP vent solenoid valve OPEN with a scan tool. Verify the scan tool Fuel Tank Pressure Sensor parameter is -0.9 to +0.9



mmHg (-0.5 to +0.5 in.H2O).



瀚慖f not within the specified range, replace the B150 fuel tank pressure sensor.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

No comments:

Post a Comment