Friday, December 13, 2019

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1311

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1311



4. Ignition ON, verify that a test lamp illuminates between ignition voltage circuit terminal D and ground.



瀚慖f the test lamp does not illuminate, test the ignition voltage circuit for a short to ground or an open/high resistance. If the circuit tests



normal and the ignition voltage circuit fuse is open, test all the components connected to the ignition voltage circuit and replace as



necessary.



5. Engine running, observe the Ignition Coil 1-6 Control Circuit Low Voltage Test Status on the scan tool. Test Status should be Ok or Not



Run.



瀚慖f test status is Malfunction test for open or short to ground.



6. Engine running, observe the Ignition Coil 1-6 Control Circuit Open Test Status on the scan tool. Test Status should be Ok or Not Run.



瀚慖f test status is Malfunction test for open circuit.



7. Engine running, observe the Ignition Coil 1-6 Control Circuit High Voltage Test Status on the scan tool. Test Status should be Ok or Not



Run.



瀚慖f test status is Malfunction test for short to voltage.



8. If all circuits test normal, test or replace the appropriate T8 ignition coil.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Ignition Coil Replacement - Bank 1 (See: Powertrain Management/Ignition System/Ignition Coil/Service and Repair/Ignition Coil



Replacement - Bank 1)



* Ignition Coil Replacement - Bank 2 (See: Powertrain Management/Ignition System/Ignition Coil/Service and Repair/Ignition Coil



Replacement - Bank 2)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for engine control module replacement, setup, and



programming



P0354



DTC P0351-P0356, P2300, P2301, P2303, P2304, P2306, P2307, P2309, P2310, P2312, P2313, P2315, or P2316 (LAU)



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P0351



- Ignition Coil 1 Control Circuit



DTC P0352



- Ignition Coil 2 Control Circuit



DTC P0353



- Ignition Coil 3 Control Circuit



DTC P0354



- Ignition Coil 4 Control Circuit



DTC P0355



- Ignition Coil 5 Control Circuit



DTC P0356



- Ignition Coil 6 Control Circuit



DTC P2300



- Ignition Coil 1 Control Circuit Low Voltage

No comments:

Post a Comment