Sunday, December 29, 2019

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1152

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1152



1. Review the Failure Records when the DTC set. Verify the engine coolant temperature is less than 125掳C (257掳F).



瀚慖f greater than the specified range, refer to Engine Overheating (See: Engine, Cooling and Exhaust/Cooling System/Testing and



Inspection/Symptom Related Diagnostic Procedures/Engine Overheating).



2. Inspect the transmission cooling system for restrictions or damage.



3. Perform the Transmission Fluid Level and Condition Check (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing



and Inspection/Component Tests and General Diagnostics/6T70/6T75 - Automatic Transmission/Transmission Fluid Level and Condition



Check) to verify correct fluid level and condition.



4. Perform the Transmission Fluid Cooler Flushing and Flow Test (See: Transmission and Drivetrain/Automatic



Transmission/Transaxle/Testing and Inspection/Component Tests and General Diagnostics/6T70/6T75 - Automatic



Transmission/Transmission Fluid Cooler Flushing and Flow Test) to verify proper transmission oil cooler flow.



5. Perform the Line Pressure Check (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Component



Tests and General Diagnostics/6T70/6T75 - Automatic Transmission/Line Pressure Check) to verify proper transmission line pressure.



6. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the



conditions that you observed from the Freeze Frame/Failure Records data.



Repair Instructions



Important: Perform the Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and



Inspection/Programming and Relearning) any time a transmission related component is serviced.



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



AF40-6 - Automatic Transmission



DTC P0218



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



DTC P0218



- Transmission Fluid Overtemperature



Diagnostic Fault Information

No comments:

Post a Comment