2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1416

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1416

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the B1 A/C Refrigerant Pressure Sensor.

2. Ignition ON, test for 4.8-5.2V between the 5V reference circuit terminal 2 and ground.

瀚慖f less than the specified range, test the 5V reference circuit for a short to ground or an open/high resistance. If the circuit tests normal,

replace K20 Engine Control Module.

瀚慖f greater than the specified range, test the 5V reference circuit for a short to voltage. If the circuit tests normal, replace the K20 Engine

Control Module.

3. Test for 4.8-5.2V between the 5V reference circuit terminal 2 and the low reference circuit terminal 1.

瀚慖f less than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace K20 Engine

Control Module.

瀚慖f greater than the specified range, test the low reference circuit for a short to voltage. If the circuit tests normal, replace the K20 Engine

Control Module.

4. Verify the scan tool A/C High Side Pressure Sensor parameter is less than 0.3V.

瀚慖f greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the K20 Engine Control

Module.

5. Install a 3A fused jumper wire between the following signal circuit terminal 3 and the 5V reference circuit terminal 2. Verify the scan tool

A/C high side pressure sensor parameter is greater than 4.8V.

瀚慖f less than the specified range, test the signal circuit for a short to ground or open/high resistance. If the circuit tests normal, replace the

K20 Engine Control Module.

6. If all circuits test normal, replace the B1 A/C Refrigerant Pressure Sensor.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* HVAC Component Replacement Reference (See: Heating and Air Conditioning/Service and Repair/Removal and Replacement)

* Control Module References (See: Testing and Inspection/Programming and Relearning)

P0560

DTC P0560

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC P0560

- System Voltage - ECM

Diagnostic Fault Information