2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 734

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 734

瀚慖f less than the specified range, test the signal circuit for a short to ground or open/high resistance. If the circuit tests normal, replace the

BCM.

3. Test for greater than 9 volts between the signal circuit terminal C and ground while commanding the rear window DOWN by using the

window switch on the driver master control.

瀚慖f less than the specified range, test the signal circuit for a short to ground or open/high resistance. If the circuit tests normal, replace the

BCM.

4. If all circuits test normal, replace the rear window switch.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Rear Side Door Window Switch Replacement (See: Windows and Glass/Windows/Service and Repair/Rear Side Door Window Switch

Replacement)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup and programming

B3824

DTC B3821 or B3824

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC B3821 00

- Left Rear Window Relay Power Circuit

DTC B3824 00

- Right Rear Window Relay Power Circuit

Diagnostic Fault Information