2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 708

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 708

瀚慖f not the specified value, replace the adjustable pedal switch.

3. Adjustable pedal switch in the FWD position, test for less than 2 ohms between the 12-volt reference terminal 5 and the signal terminal 6.

瀚慖f greater than the specified range, replace the adjustable pedal switch.

4. Adjustable pedal switch in the RWD position, test for less than 2 ohms between the 12-volt reference terminal 5 and the signal terminal 4.

瀚慖f greater than the specified range, replace the adjustable pedal switch.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Accessory Switch Replacement (Except Cadillac) (See: Instrument Panel, Gauges and Warning Indicators/Service and Repair/Accessory

Switch Replacement (Except Cadillac))Accessory Switch Replacement (Cadillac) (See: Instrument Panel, Gauges and Warning

Indicators/Service and Repair/Accessory Switch Replacement (Cadillac))

* Control Module References (See: Testing and Inspection/Programming and Relearning) for the MSM replacement, setup, and programming

B3606

DTC B3606

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC B3606 01

- Adjustable Foot Pedal Position Sensor Circuit Short to Battery

DTC B3606 06

- Adjustable Foot Pedal Position Sensor Circuit Short to Ground or Open

Diagnostic Fault Information

Circuit/System Description

The memory seat module (MSM) monitors the location of the adjustable pedals using the adjustable pedals position sensor. The adjustable pedals

position sensor is supplied with 5-volt reference and ground circuits from the MSM. The position sensor signal circuit is referenced from ground

within the MSM. The signal voltage monitored by the MSM ranges from 0.45-4.55 volts.

Conditions for Running the DTC

System voltage to the MSM must be 9-16 volts.

Conditions for Setting the DTC

The position sensor input to the MSM is not within the 0.45-4.55 volt range.

Action Taken When the DTC Sets

Memory recall functions will be suspended.

Conditions for Clearing the DTC