Wednesday, November 27, 2019

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 2028

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 2028



Circuit/System Description



Control modules connected to the mid speed or chassis high speed GMLAN serial data circuits monitor for serial data communications during



normal vehicle operation. Operating information and commands are exchanged among the control modules when the ignition switch is in any



position other than OFF. The mid speed or chassis high speed GMLAN serial data bus uses a terminating resistor that is in parallel with the mid



speed or chassis high speed GMLAN (+) and (-) circuits.



Conditions for Running the DTC



The system voltage is between 9-16 V.



Conditions for Setting the DTC



A supervised periodic message that includes the transmitter module availability has not been received.



Action Taken When the DTC Sets



Specific subsystems will not function.



Conditions for Clearing the DTC



* A current DTC clears when the malfunction is no longer present.



* A history DTC clears when the module ignition cycle counter reaches the reset threshold of 50, without a repeat of the malfunction.



Diagnostic Aids



* Use the Data Link References (See: Powertrain Management/Computers and Control Systems/Information Bus/Testing and



Inspection/Initial Inspection and Diagnostic Overview) to identify the mid speed or chassis high speed GMLAN serial data modules.



* Some control modules may not have internal protection for specific voltage outputs and may open a battery positive voltage or ignition



voltage source fuse. If a voltage input fuse is open and no short is found in that circuit, ensure that no control module output voltage circuit is



shorted to ground before replacing the control module.



* An open in the DLC ground circuit terminal 5 will allow the scan tool to operate to set up the vehicle on the tool and then not communicate



with the vehicle. When the scan tool is to the point of communicating with the vehicle, a message on the scan tool will indicate "no CANdi



module detected" and will not communicate.



Reference Information



Schematic Reference



Data Communication Schematics (See: Powertrain Management/Computers and Control Systems/Information Bus/Diagrams/Electrical Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Data Link Communications Description and Operation (See: Powertrain Management/Computers and Control Systems/Information



Bus/Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)

No comments:

Post a Comment