Saturday, November 23, 2019

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1953

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1953



Operation/AF40-6 - Automatic Transmission/Transmission Adaptive Functions).



* Wiring harness-Refer to Automatic Transmission Wiring Harness Replacement (See: Transmission and Drivetrain/Automatic



Transmission/Transaxle/Wiring Harness/Service and Repair).



6T70/6T75 - Automatic Transmission



DTC P2719-P2721



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P2719



- Clutch Pressure Control (PC) Solenoid 4 System Performance



DTC P2720



- Clutch Pressure Control (PC) Solenoid 4 Control Circuit Low Voltage



DTC P2721



- Clutch Pressure Control (PC) Solenoid 4 Control Circuit High Voltage



Diagnostic Fault Information



Circuit/System Description



The clutch pressure control (PC) solenoid 4 is part of the control solenoid valve assembly which has no serviceable components. The normally low



PC solenoid 4 regulates and directs oil pressure to the 2-6 clutch regulator valve. Increasing PC solenoid 4 pressure, increases pressure to the 2-6



clutch regulator valve. The TCM varies the current to the PC solenoid 4 through a low side driver. Increasing the current to PC solenoid 4 increases



oil pressure by closing OFF the solenoid exhaust port. Decreasing the current to PC solenoid 4 decreases oil pressure by opening the exhaust port.



PC solenoid 4 power is supplied by the TCM through a high side driver (HSD). The HSD protects the circuit and components from excessive



current flow. If excessive current flow is detected, the HSD will turn OFF. When the fault is corrected the HSD will reset.



Conditions for Running the DTC



P2719



* The engine speed is greater than 400 RPM for 5 seconds.



* The ignition voltage is 8.6 volts or greater.



* DTC P2719 has not set this ignition cycle.



P2720



* The engine speed is greater than 400 RPM for 5 seconds.



* The ignition voltage is 8.6 volts or greater.



* DTC P2720 has not set this ignition cycle.



P2721



* The engine speed is greater than 400 RPM for 5 seconds.



* The ignition voltage is 8.6 volts or greater.



* DTC P2721 has not set this ignition cycle.



Conditions for Setting the DTC



P2719



The TCM detects an internal electrical malfunction on the clutch PC solenoid 4 control circuit where the measured PC solenoid 4 current does not



equal the commanded clutch PC solenoid 4 current for 5 seconds.



P2720



The TCM detects a short to ground on the clutch PC solenoid 4 control circuit for 1 second.

No comments:

Post a Comment