2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 423
The control module detects that the 12V system voltage is less than 9 volts for 5 seconds.
B1325 07
The control module detects that the 12V system voltage is greater than 18 volts for 5 seconds.
Action Taken When the DTC Sets
* The control module immediately disables all outputs when an out of range voltage condition has been detected, with the exception of
GMLAN, which is disabled after a 3 minute delay.
* The setting of other DTCs is inhibited.
Conditions for Clearing the DTC
The DTC clears when the malfunction is no longer present.
Diagnostic Aids
* A high or low voltage value in multiple modules indicates a concern in the charging system.
* Overcharging with a battery charger can cause this DTC to set.
Reference Information
Schematic Reference
* Control Module References (See: Testing and Inspection/Programming and Relearning)
* Power Distribution Schematics (See: Diagrams/Electrical Diagrams/Starting and Charging/Power and Ground Distribution/System
Diagram/Power Distribution Schematics)
* Ground Distribution Schematics (See: Diagrams/Electrical Diagrams/Starting and Charging/Power and Ground Distribution/System
Diagram/Ground Distribution Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Charging System Description and Operation (See: Starting and Charging/Charging System/Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Testing
1. Engine running, accessories OFF, measure and record the battery voltage at the 12V battery terminals. The voltage should be between 12.6
and 15.0 volts.
瀚慖f not within the specified range, refer to Charging System Test (See: Starting and Charging/Testing and Inspection/Component Tests
and General Diagnostics/Charging System Test).
2. Ignition OFF, disconnect the harness connectors at the appropriate module.
3. Ignition OFF and scan tool disconnected, open and close the driver door, and wait 1 minute. Test for less than 5 ohms between the ground
circuit and ground.
瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.
4. Verify that a test lamp illuminates between the 12V B+ circuit terminals and ground.
瀚慖f the test lamp does not illuminate, test the 12V B+ circuit for a short to ground or an open/high resistance.
No comments:
Post a Comment