Monday, November 18, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 963

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 963

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC C0569 00

- System Configuration Error

Circuit/System Description

The electronic brake module (EBCM) receives a serial data message from each of the network modules. Each module contains its own unique

identification (ID) code that must be programmed into a new the EBCM.

Conditions for Running the DTC

Ignition ON.

Conditions for Setting the DTC

The EBCM has not undergone the programming procedure.

Action Taken When the DTC Sets

* The EBCM disables the ABS/traction control system (TCS)/vehicle stability enhancement system (VSES) for the duration of the ignition

cycle.

* The ABS indicator illuminates.

* The red Brake indicator illuminates.

* The Stability Control indicator illuminates.

* The driver information center (DIC) displays All Wheel Drive OFF, Service StabiliTrak and Service Traction Control messages.

Conditions for Clearing the DTC

A current DTC will clear when the EBCM is programmed.

Diagnostic Aids

A newly replaced EBCM will set DTC C0569 on its initial ignition ON cycle.

Reference Information

Schematic Reference

Antilock Brake System Schematics (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

ABS Description and Operation (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Description and Operation/ABS

Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Verify that C0569 is not set.

If the DTC is set, program the EBCM. If the DTC resets, replace the EBCM.

No comments:

Post a Comment