2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 872
Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Verify that no DTCs are set in the ECM.
If DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code Descriptions/Diagnostic Trouble Code
(DTC) List - Vehicle).
Antilock Brake System - Non-Hybrid Less than 3900 kg (8600 lb) GVW
DTC C0245
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC C0245 00
- Wheel Speed Sensor Frequency Error
Circuit/System Description
The wheel speed sensor receives ignition voltage from the electronic brake control module (EBCM) and provides an output signal to the EBCM. As
the wheel spins, the wheel speed sensor sends the EBCM a DC square wave signal, and uses the frequency of the square wave signal to calculate
the wheel speed.
Conditions for Running the DTC
* Ignition voltage is greater than 9.5 volts.
* No wheel speed sensor faults exist.
* Brake is not applied.
* Vehicle is not cornering.
Conditions for Setting the DTC
Wheel speed differences between one wheel and the others is greater than 25 percent.
Action Taken When the DTC Sets
* The EBCM disables the traction control system (TCS) and vehicle stability enhancement system (VSES) for the duration of the ignition
cycle.
* The ABS indicator illuminates.
* The StabiliTrak indicator illuminates.
* The driver information center (DIC) displays all wheel drive (AWD) OFF/Service Traction Control/Service StabiliTrak message.
Conditions for Clearing the DTC
* The DTC becomes history when the conditions for setting the DTC are no longer present.
No comments:
Post a Comment