Sunday, November 17, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 867

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 867

DTC C0196 55

- Yaw Rate Circuit Expected Number of Transition/Events Exceeded

DTC C0196 5A

- Yaw Rate Circuit Plausibility Failure

DTC C0196 0F

- Yaw Rate Circuit Erratic

Circuit/System Description

The lateral accelerometer and the yaw rate sensors are combined into one sensor external to the electronic brake control module (EBCM). The

vehicle stability enhancement system (VSES) uses the lateral accelerometer input when calculating the desired yaw rate. The EBCM recieves the

yaw/lateral accelerometer sensor data from dedicated serial data circuits.

Conditions for Running the DTC

* Ignition ON.

* Ignition voltage is greater than 10 volts.

Conditions for Setting the DTC

* The yaw/lateral accelerometer sensor fails an internal self test.

* The correlation error between the yaw/lateral accelerometer sensor and steering angle sensor.

Actions Taken when the DTC Sets

* The EBCM disables the StabiliTrak for the duration of the ignition cycle.

* A DIC message and/or a warning indicator may be displayed.

Conditions for Clearing the DTC

* The condition for the DTC is no longer present.

* The EBCM clears the history DTC when a current DTC is not detected in 40 consecutive drive cycles.

Diagnostic Aids

An incorrectly mounted sensor can cause these faults.

Reference Information

Schematic Reference

Antilock Brake System Schematics (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

ABS Description and Operation (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Description and Operation/ABS

Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information

Circuit/System Verification

1. Ignition On, verify that DTC U2142 or C0292 is not set.

No comments:

Post a Comment