Monday, November 18, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 959

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 959

Conditions for Running the DTC

* The ignition switch is in the ON position.

* Ignition voltage is greater than 9.5 volts.

Conditions for Setting the DTC

The EBCM receives an invalid message from another module over GMLAN which causes EBCM to deactivate ABS, VSES, TCS, etc.

Action Taken When the DTC Sets

One or more of the following actions may occur:

* The EBCM disables the ABS/TCS/VSES for the duration of the ignition cycle.

* The dynamic rear proportioning (DRP) may be disabled and the Brake Warning indicator may turn ON.

* The Stability Caution indicator turns ON.

* The driver information center (DIC) displays the SERVICE STAB SYS message.

* The DIC displays the TRACTION FAILED message.

Conditions for Clearing the DTC

* The condition for the DTC is no longer present.

* The EBCM automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.

Reference Information

Schematic Reference

Antilock Brake System Schematics (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

ABS Description and Operation (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Description and Operation/ABS

Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for Scan Tool Information

Circuit/System Verification

Note: Diagnose any other DTCs before attempting to diagnose C0561.

1. With a scan tool, view the EBCM invalid signal data in the Enhanced DTC Data.

2. Refer to appropriate module for diagnosing the invalid signal data.

3. Do not replace the EBCM due to this DTC fault.

Gasoline Without LY6

DTC C0561 (Gasoline Without LY6)

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

No comments:

Post a Comment