Monday, November 18, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 965

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 965

If the DTC is set, perform the RCDLR tire type and pressure selection setup with the scan tool and cycle the ignition. If the DTC resets, replace the

RCDLR.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for RCDLR replacement, setup, and programming

MP 3010-NP0 - Transfer Case

DTC C0569

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC C0569 4B

- System Configuration Error Calibration Not Learned

Circuit/System Description

* This is an internal fault detection of the transfer case shift control module (TCCM). No external circuits are involved.

* This DTC is set anytime a TCCM is replaced or reprogrammed.

* The automatic transfer case (ATC) motor learn procedure must be performed to erase this DTC. The motor learn procedure allows the

module to learn where the shift rails are located.

Conditions for Running the DTC

* Ignition ON.

* System voltage 10.5-18 V.

Conditions for Setting the DTC

The ATC motor learn procedure for a new or reprogrammed TCCM has not been performed.

Action Taken When the DTC Sets

* Mode shifting is disabled until the ATC motor learn procedure has been performed.

* The SERVICE 4WD indicator illuminates.

* No mode position LED's illuminated.

Conditions for Clearing the DTC

The TCCM clears the DTC once the ATC motor learn procedure has been successfully performed.

Reference Information

Schematic Reference

Transfer Case Control Schematics (See: Transmission and Drivetrain/Transfer Case/Diagrams/Electrical Diagrams/MP 3010-NP0 - Transfer Case)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

No comments:

Post a Comment