Sunday, November 17, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 874

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 874

* Ignition voltage is greater than 9.5 volts.

* No wheel speed sensor faults exist.

* Brake is not applied.

* Vehicle is not cornering.

* No wheel spinning is detected.

Conditions for Setting the DTC

Wheel speed differences between one wheel and the others is greater than 25 percent.

Action Taken When the DTC Sets

* Antilock brake system (ABS), traction control system (TCS) and vehicle stability enhancement system (VSES) are disabled for the remainder

of the ignition cycle.

* The ABS and Stabilitrak indicator turns ON.

* The service Traction Control and Stabilitrak displays on the DIC.

Conditions for Clearing the DTC

* The DTC becomes history when the conditions for setting the DTC are no longer present.

* The history DTC clears after 100 malfunction-free ignition cycles.

* The EBCM receives a clear code command from the scan tool.

Diagnostic Aids

* Faulty wheel speed sensor will not set this DTC.

* A vehicle using a space saver spare will not set this code.

Reference Information

Schematic Reference

Antilock Brake System Schematics (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

ABS Description and Operation (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Description and Operation/ABS

Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Inspect for one tire that has improper air pressure or improper size.

C0252

DTC C0252

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

No comments:

Post a Comment