2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 343

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 343

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Transfer Case Shift Control Switch Replacement (Without SLT) (See: Powertrain Management/Transmission Control Systems/Sensors and

Switches - Transmission and Drivetrain/Sensors and Switches - Transfer Case/Four Wheel Drive Selector Switch/Service and Repair)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for TCSCM replacement, setup, and programming

* Transfer Case High/Low Clutch Reset (See: Transmission and Drivetrain/Transfer Case/Testing and Inspection/Symptom Related

Diagnostic Procedures/MP 3023/3024-NQH - Transfer Case/Transfer Case High/Low Clutch Reset)

MP 3010-NP0 - Transfer Case

DTC B0785

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC B0785 01

- 2 High Indicator Circuit Short to Battery

DTC B0785 06

- 2 High Indicator Circuit Short to Ground or Open

Diagnostic Fault Information

Circuit/System Description

The 2 High indicator circuit consists of a light emitting diode (LED), a LED feed circuit and a LED control circuit. The indicator dimming control

circuit is the LED feed circuit and continuously supplies voltage to the 2 High, Auto 4WD, and 4 High LEDs. When the 2 High mode has been

selected by the driver, the transfer case shift control module (TCCM) provides a ground through the 2 High indicator control circuit illuminating the

LED. The TCCM tests the 2 High indicator circuit for unexpected voltage by monitoring the B+ supplied by the BCM on the indicator dimming

control circuit by grounding the 2 High indicator control circuit for 2 seconds during the bulb test at key ON.

Conditions for Running the DTC

B0785 01

* Ignition ON

* System voltage 10-18 V

* Instrument panel lights not dimmed.

* Daylight running lights MUST be commanded ON.

* Circuit tested when the 2 High indicator is commanded ON.

B0785 06

* Ignition ON

* System voltage 10-18 V

* Instrument panel lights not dimmed.

* Daylight running lights MUST be commanded ON.

* Circuit tested when the 2 High indicator is commanded OFF.

Conditions for Setting the DTC