Monday, November 18, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 954

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 954

* History DTCs can be cleared using a scan tool.

Diagnostic Aids

* DTC P0550 detects the wrong copy of non-volatile memory in RAM or a RAM read/write failure.

* DTC P0550 detects a non-volatile memory write error.

* DTC P0550 detects a corruption of the EPROM/Flash memory.

* When attempting to set TCCM internal DTCs, let the engine run for at least 1 minute and then shut the engine OFF for 30 seconds.

Following this procedure will allow for a complete TCCM shutdown. Reprogram the TCCM and retest the DTC to see if the DTC resets.

* A low voltage condition can sometimes falsely set this DTC. Attempt to clear this DTC and retest.

Reference Information

Schematic Reference

Transfer Case Control Schematics (See: Transmission and Drivetrain/Transfer Case/Diagrams/Electrical Diagrams/MP 3023/3024-NQH -

Transfer Case)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Transfer Case Description and Operation (See: Transmission and Drivetrain/Transfer Case/Description and Operation/MP 3023/3024-NQH -

Transfer Case/Transfer Case Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information.

Circuit/System Verification

1. Engine running. Let the engine run for at least 1 minute.

2. Ignition OFF for at least 30 seconds to allow for the complete shutdown of the TCCM.

3. Ignition ON, verify that DTC C0550 is not set.

瀚慖f DTC C0550 sets, reprogram the TCCM. If the DTC resets, replace the TCCM. Perform the ATC motor learn procedure.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Control Module References (See: Testing and Inspection/Programming and Relearning) for TCSCM replacement, setup, and programming

* Transfer Case High/Low Clutch Reset (See: Transmission and Drivetrain/Transfer Case/Testing and Inspection/Symptom Related

Diagnostic Procedures/MP 3023/3024-NQH - Transfer Case/Transfer Case High/Low Clutch Reset)

C0558

DTC C0558

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

No comments:

Post a Comment