2010 Mercedes Benz C 300 (204.054) V6-3.0L (272.947) Page 761

Figure legend

- 003Multimeter

- N10/2f3 (Fuse 3)

- N10/2kA (Fuel pump relay)

Test prerequisite

- Carry out test only if complaint exists.

Test sequence

- Switch off ignition.

- Insert bridge.:

- Bridge between sockets [F.4] 100 and [F.17] 113 of the 126-pole socket box tester.

- Unplug component N10/2f3 (Fuse 3) from component N10/2 (Rear SAM control unit with fuse and relay module).

- Measurement is performed at the contact slot of component N10/2f3 (Fuse 3).

- Measure direct current with multimeter between sockets [F10f3] -.- and [F10f3] -.-

- Switch on ignition.

- Component M3 (Fuel pump) runs.

Specified value

- Amperage[4...9] A

Question

- Is the measurement value OK?