NO
The measurement value is not OK.Possible cause and remedy
- Test current consumption of component M3 (Fuel pump).
- Fuel filter with integrated pressure regulator
NO
Figure legend
- A -ConnectionTest cable 35-pin socket box
- 001 -Sockets of component N3/10 (ME-SFI [ME] control unit)
- 05 -35-pin socket box
- 050 -126-pin socket box
- 108 -Test cable 266 589 01 63 00
- N3/10 (ME-SFI [ME] control unit)
- II 1-63ConnectionTest cable
- III 64-126ConnectionTest cable
Warning!
- Connection A of test cable 108 may NOT be connected to connection B of the 126-pin socket box (050).
Continue to test with button F2
Figure legend
- 043Pressure gage
- 055Measuring beaker
- 069Pressure hose(119 589 04 63 00)
Warning!On USA vehicles with code 917 ( PZEV ), the sealing ring of the service valve for the protective cap must be replaced.Test sequence
- Switch off ignition.
- Connect test pressure gauge.
- Connect socket box (126-pin) to component N3/10 (ME-SFI [ME] control unit).
- Insert bridge.:
- Bridge between sockets [F.4] 100 and [F.17] 113 of the 126-pole socket box tester.
- Switch on ignition.
- Component M3 (Fuel pump) runs.
- Warning! Insert bridge only for a short time.
Specified value
- Pressure[3.7...4.2] bar
No comments:
Post a Comment