Thursday, April 18, 2019

2020 Mercedes Benz Truck ML 350 Technical Service Bulletin # LI33-15_P-0502452 Date: 120817

2020 Mercedes Benz Truck ML 350 Technical Service Bulletin # LI33-15_P-0502452 Date: 120817



2020 Mercedes Benz Truck ML 350 4MATIC (164.186) V6-3.5L (272.967) Page 37



Suspension - Grunt/Creak Sound From Area Of Front Axle



Grunting/creaking noises from area of front axle



Themen-Nummer LI33.15-P-050245



Version 2



Konstruktionsgruppe 33.15 Axle links



Stand 08-17-2012



Gultigkeit Model 164/251



Anderungsgrund Content and parts attachedment revised



Beanstandung:



Grunting/creaking noises from the area of the front axle when braking, driving over surface undulations, negotiating tight corners, or while



maneuvering at low speeds.



Anhange



Ursache:



Cause 1: Bolt torque connecting the crash strut with the undenfloor (M10 bolt) too low, see "Bild 1.pdf" in attachment.



Cause 2: Bump stop of rear rubber mount comes into contact with external shell.



Cause 3: End faces of front rubber mounts rub against the body and cause noises during certain movements of the transverse control arms.



Anhange



Abhilfe:



Perform a test drive and use e.g. the Steelman Chassis Ear to locate the source of the noise and identify the relevant cause.



If the source cannot be clearly identified, work through the following measures individually. The note (see below) must be observed!



1.) Clean M10 bolt on crash strut and install using a thread locking agent (e.g. Loctite 270).



Tighten bolt to the increased torque of 80 Nm.



Refer to reference sound file 1.mp3



2.) Completely wax rear rubber mount of lower transverse control arm.



Refer to reference sound file 3.mp3



3.) Replace rubber mounts of upper transverse control arms.



4.) Replace front rubber mount of lower transverse control arm.



Refer to reference sound file 2.mp3



Note



^ A test drive must be performed after completing each individual step of the remedy. If the noise is no longer reproducible no further



remedial action should be taken.



^ A new repair method has been defined according to which both rubber mounts of the upper transverse control arm and the front rubber



2020 Mercedes Benz Truck ML 350 4MATIC (164.186) V6-3.5L (272.967) Page 38



mount of the lower transverse control arm are replaced separately.



Symptome



Teile



WIS-Referenzen



2020 Mercedes Benz Truck ML 350 4MATIC (164.186) V6-3.5L (272.967) Page 39

No comments:

Post a Comment