Monday, April 29, 2019

2010 Land Rover Range Rover Sport (LS) V8-5.0L Technical Service Bulletin # TECLTB003222 Date: 110815

2010 Land Rover Range Rover Sport (LS) V8-5.0L Technical Service Bulletin # TECLTB003222 Date: 110815



Body - Upper Windshield Finisher Is Loose



No: LTB00322 (Issue 2)



15 AUG 2010



ISSUE '2' CHANGES ARE HIGHLIGHTED IN GRAY



2010 Land Rover Range Rover Sport (LS) V8-5.0L Page 63



SECTION: 501



Upper Windshield Finisher Loose



AFFECTED VEHICLE RANGE



CONDITION SUMMARY:



Situation:



The windshield finisher may be loose or a wind noise may be evident. This may be caused by body tolerances in relation to the upper windshield



finisher profile.



Action:



In the event of a customer concern of the above, refer to the Repair Procedure outlined below to inspect and either refit or replace the upper



windshield finisher.



PARTS



WARRANTY



REPAIR PROCEDURE



INSPECT AND REFIT / REPLACE UPPER WINDSHIELD FINISHER



1. Inspect the upper windshield finisher for looseness and damage: (Figure 1)



^ If the finisher has no damage but is loose, continue to step 2.



^ If the finisher is damaged and loose, remove and replace the finisher; continue to step 3.



2. Remove the loose and undamaged upper windshield finisher:



^ Completely clean the finisher.



2010 Land Rover Range Rover Sport (LS) V8-5.0L Page 64



NOTE:



Ensure the upper windshield finisher and windshield is free from dirt and is completely dry.



3. Apply suitable sealer along the full length of the windshield finisher 'U' section. (Figure 2)



4. Install the upper windshield finisher, ensuring it is located properly.



5. Using a suitable solvent and cloth, remove any excess sealer. (Figure 3)

No comments:

Post a Comment