1.2. Test current consumption of component Y22/9 (Intake manifold tumble flap switchover valve).
Figure legend
- A -ConnectionTest cable 35-pin socket box
- 001 -Sockets of component N3/10 (ME-SFI [ME] control unit)
- 05 -35-pin socket box
- 050 -126-pin socket box
- 108 -Test cable 266 589 01 63 00
- N3/10 (ME-SFI [ME] control unit)
- II 1-63ConnectionTest cable
- III 64-126ConnectionTest cable
Warning!
- Connection A of test cable 108 may NOT be connected to connection B of the 126-pin socket box (050).
Continue to test with button F2
Test prerequisites
- Actuation is not OK.
Test sequence
- Measure direct current with multimeter between sockets (F.4) 100 and (M.19) 19 of the 126-pole socket box tester.
- Switch on ignition.
Specified value
- Amperage[0.2...0.6] A
Question
- Is the measurement value OK?
YES
The measurement value is OK.Further possible causes of fault
- Vacuum unit for variable intake manifold
End of test
NO
The measurement value is not OK.Possible cause and remedy
- Voltage supply of component Y22/9 (Intake manifold tumble flap switchover valve)(N10/1f57 (Fuse 57))
No comments:
Post a Comment