2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Technical Service Bulletin # 11-042 Date: 110420
CVT - Output Speed Sensor Service
Classification: AT11-007
Reference: NTB11-042
Date: April 20, 2011
2007-2011 ALTIMA, JUKE, ROGUE, SENTRA; CVT OUTPUT SPEED SENSOR SERVICE
APPLIED VEHICLES:
2007-2011 Altima (C/L32) QR25 ONLY
2011 Juke (F15)
2008-2011 Rogue (S35)
2007-2011 Sentra (B16) MR20 & QR25 ONLY
SERVICE INFORMATION
If the Output Speed Sensor has been removed and replaced for any reason:
2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Page 316
NOTE:
Input/Turbine Speed Sensor does not require shims. That Sensor is flush mounted to CVT casting.
The correct number of spacer shims must be installed between the Sensor and the CVT body.
Refer above for shim number application chart.
SERVICE PROCEDURE
1. Determine required number of shims by model:
2. Assemble the Output Speed Sensor with the proper 0-ring.
3. Place bolt with attached washers through hole on the Sensor.
4. After determining the correct number of washers for the vehicle, place the shims over the portion of the bolt that is exposed below the sensor
body.
5. Assemble as seen below: Torque retaining bolt to 5.9 Nm (0.6 kg-m, 52 in-lb)
2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Page 317
No comments:
Post a Comment