Friday, February 15, 2019

2010 Mercedes Benz C 300 (204.054) V6-3.0L (272.947) Page 3275


- Transmission mode selection



- Drive position selection



-------------------------------------------------



Test 1: Remedial action in the event of implausible signals from control unit N30/4 (Electronic Stability Program control unit)



1. Remedial action in the event of implausible signals from control unit N30/4 (Electronic Stability Program control unit)



Operation number of operation texts and work units or standard texts and flat rates:27-0641WARNING



- This is not a function error of control module N15/3 (ETC [EGS] control unit) and does not justify replacement.



Possible cause for the entry of this event code



- Operational fault of component N30/4 (Electronic Stability Program control unit)



Possible measures



- Read out fault memory of control unit N30/4 (Electronic Stability Program control unit).



- Process displayed fault codes in control module N30/4 (Electronic Stability Program control unit).



End of test



253900



The fuel pressure sensor of the low pressure circuit is malfunctioning.



Test 1: Check component B4/7 (Fuel pressure sensor).



Test 2: Possible cause:



- B4/7 (Fuel pressure sensor)



Affected functions:



- Engine diagnosis



- Fuel system



1. Check component B4/7 (Fuel pressure sensor).



Test 1.1: Check component B4/7 (Fuel pressure sensor) using actual value.



Test 1.2: Check power supply of component B4/7 (Fuel pressure sensor).



Test 1.3: Test wiring to component B4/7 (Fuel pressure sensor).



1.1. Check component B4/7 (Fuel pressure sensor) using actual value.



Warning!Communication with ECU required.



1.2. Check power supply of component B4/7 (Fuel pressure sensor).



Test prerequisite



- The actual value is not o.k.



Test sequence



- Switch off ignition.



- Unplug connector of pressure sensor B4/7 (Fuel pressure sensor).



- Measure direct voltage with multimeter between sockets (B4/7) 3 and (B4/7) 1



- Switch on ignition.



Specified values



- Voltage : [4.8 ... 5.3] V



Question



- Is the measurement value OK?

No comments:

Post a Comment