2010 Mercedes Benz C 300 (204.054) V6-3.0L (272.947) Page 1626

Test 1.1.3.1.2: Wiring diagram of CAN bus

1.1.3.1.1. Arrangement diagramNOTESome of the control units listed are special equipment and not installed in every vehicle.

Location diagram (with special equipment)

Figure legend

- A1 (Instrument cluster)

- A89 (DTR controller unit)

- N3/9 (CDI control unit)

- N3/10 (ME-SFI [ME] control unit)

- N15/3 (ETC [EGS] control unit)

- N15/5 (Electronic selector lever module control unit)

- N47-5 (ESP, SPS [PML] and BAS control unit)

- N51 (AIRmatic with ADS control module)

- N63/1 (DTR control module)

- N71 (Headlamp range adjustment control module)

- N73 (EIS [EZS] control unit)

- N80 (Steering column module)

- N93 (Central gateway control unit)

- N97 (Rear axle level control system control module)

- X11/4 (Diagnosis test connector)

- X30/5 (Left voltage distributor (CAN) connector)

- Installation point of plug connection X30/5 (Left voltage distributor (CAN) connector)

- Communication with ECU required

1.1.3.1.2. Wiring diagram of CAN bus

Note

- WIS is not available on this system.

- It is not possible to display the requested WIS document [ pe0019p2200da ].

- You can start WIS on another system and display the WIS document by entering the document number [ pe0019p2200da ] in the 'Contents'