1.1.3.2.1.4. Check power supply at control unit Y3/8n4 (Fully integrated transmission control (VGS) control unit).
Operation number of operation texts and work units or standard texts and flat rates:27-0641Test prerequisite
- Battery voltage is OK.
- Fuse N10/1f46 (Fuse 46) in component N10/1 (Driver-side SAM control unit with fuse and relay module) is o.k.
Test sequence
- Switch off ignition.
- Separate plug connection at transmission.
- Measure voltage in transmission wiring harness using a multimeter.
- Switch on ignition.
Measure direct voltage with multimeter between 5 and 4Specified value
- Voltage [8,5...16,4] V
Question
- Is the measurement value OK?
YES
The measurement value is OK.Further causes
- The diagnosis line is not OK
- Perform test on diagnosis line.
Press button "F2" for further tests
Test K cable to control unit Y3/8n4 (Fully integrated transmission control (VGS) control unit).
Operation number of operation texts and work units or standard texts and flat rates:27-0641Test prerequisite
No comments:
Post a Comment