Tuesday, October 3, 2017

Mercedes Benz E 63 AMG Sedan Keyless Entry/Start - Replacement And Diagnosis Revision

********************************************************************
2010 Mercedes Benz E 63 AMG Sedan (212.077) V8-6.3L (156.985) Copyright ? 2013, ALLDATA 10.52SS Page 1
Vehicle: All Technical Service Bulletins
Keyless Entry/Start - Replacement And Diagnosis Revision
Date: May 17, 2012
Order No.: S-B-80.57/57a
Supersedes: S-B-80.57/57, May 16, 2012
Group: 80
Revision a: Revised to Indicate Paper SDS Process Involvement
SUBJECT: MY-All, Models 164, 166, 171, 172, 203, 204, 207, 209, 211, 212, 218, 219, 231, 245, 251
Replacement and Diagnosis of FBS3 and FBS4 Components
Troubleshooting in the event of problems with drive authorization or access authorization has been revised:
Procedure:
1. Perform quick test
- Control units
- Body
- EZS
- Special procedures -> "Guided test of transmitter key" or "Guided test of drive authorization system".
2. Select the applicable problem here.
3. In the event of problems with unlocking/locking the vehicle: Carry out a guided test of transmitter key.
4. In the event of problems with starting the engine: Carry out guided test of drive authorization system [DAS]. (A guided diagnosis clearly
determines the defective part.)
These tests check the functional interplay of the electronic ignition lock (EIS), electric steering lock (ELV) and transmitter key:
- "Perform quick test"
- "Check drive authorization system (after quick test)"
- "Check individual parts of the drive authorization system:.......... after Perform quick test"
NOTE:
Do not replace any parts without first performing a guided diagnosis.
Both vehicle keys should be available for an efficient and correct diagnosis. Therefore, ask the customer before their appointment to make
both vehicle keys available on the repair date. If this is not possible, make absolutely certain that you have the correct diagnosis path during
diagnosis with Xentry Diagnostics. Completely carry out the diagnosis up to and including the note referring to the part to be replaced.
Implemented diagnosis steps will be stored in the EZS and ELV control units. When the parts are inspected by warranty claims, the diagnosis
steps taken by the workshop can be identified.
At the end of the respective test steps, a note with the request to prepare a printout appears on the display. This printout and the printout of the
quick test must be uploaded to Paperless SDS.
During the warranty inspection we will check whether the parts have been justifiably removed, based on the diagnosis results. If this is not the
case or if the diagnosis printouts are not uploaded to Paperless SDS, the warranty claim may be denied. The same applies when the requested
parts are not returned. All parts requested by the inspection station are to be returned according to the warranty parts return process.
These parts are explicitly excluded from the Theft-Relevant Parts Ordering Policy.