Mercedes Benz C 63 AMG Technical Service Bulletin #P-54_18-233
Electrical - Ashtray Illumination Connector Placement
Date: June 3, 2010
Order No: P-B-54.18/233
Date: 1006032010 Mercedes Benz C 63 AMG Sedan (204.077) V8-6.3L (156.985)
Page 354
Group: 54
SUBJECT: MY-All, Models 204 with Smoker Package
Ashtray Illumination Connector
Pay attention to the correct contacting for the connectors of the ashtray illumination and label illumination for the ashtray cover. Remember to mark
the lines before disconnecting them and upon conclusion of the work, carry out a function check with the ignition switched on and the interior
illumination activated.
Carry out function check for other-make installations in the area of the center console (front or rear) and produce the original condition of plug
couplings. As a result connected work must be billed to the customer and must not be invoiced via warranty and goodwill.
Refer to SI54.21-P-0007A Malfunctions due to other-make installations.
Should vehicle electronics fail in any control unit with no corresponding fault entry, check for foreign parts in the interior wiring harness of the
vehicle. (Note example of TV enable module for COMAND APS NTG2 in Figure 1.)
Sample malfunctions might be:
^ Random unlocking or locking of the vehicle while driving
^ Temporary or continuous set off of the hazard warning system
^ Sudden rise in travel distance in the IC.
The presence of non-approved accessories will null and void any warranty obligations and material defect liability obligations, where the installation
of non-approved accessories has caused faults or damage.
Repair costs must then be charged to the customer and they must not be settled through warranty claims.
Electrical - Ashtray Illumination Connector Placement
Date: June 3, 2010
Order No: P-B-54.18/233
Date: 1006032010 Mercedes Benz C 63 AMG Sedan (204.077) V8-6.3L (156.985)
Page 354
Group: 54
SUBJECT: MY-All, Models 204 with Smoker Package
Ashtray Illumination Connector
Pay attention to the correct contacting for the connectors of the ashtray illumination and label illumination for the ashtray cover. Remember to mark
the lines before disconnecting them and upon conclusion of the work, carry out a function check with the ignition switched on and the interior
illumination activated.
Carry out function check for other-make installations in the area of the center console (front or rear) and produce the original condition of plug
couplings. As a result connected work must be billed to the customer and must not be invoiced via warranty and goodwill.
Refer to SI54.21-P-0007A Malfunctions due to other-make installations.
Should vehicle electronics fail in any control unit with no corresponding fault entry, check for foreign parts in the interior wiring harness of the
vehicle. (Note example of TV enable module for COMAND APS NTG2 in Figure 1.)
Sample malfunctions might be:
^ Random unlocking or locking of the vehicle while driving
^ Temporary or continuous set off of the hazard warning system
^ Sudden rise in travel distance in the IC.
The presence of non-approved accessories will null and void any warranty obligations and material defect liability obligations, where the installation
of non-approved accessories has caused faults or damage.
Repair costs must then be charged to the customer and they must not be settled through warranty claims.
