2010 Mercedes Benz Truck GL 350 BLUETEC (164.825) V6-3.0L DSL Turbo (642.820)
Vehicle: All Technical Service Bulletins
Fuel System - 'Clean Fuel Filter' Mssg. And DTC's Stored
Combination message: "Clean fuel filter" as well as fault code (FC) 162500, P226997 or 171600 stored in engine control unit
Topic number LI47.20-P-054958
Version 1
Design group 47.20 Fuel pump, filter
Date 11-14-2012
Validity All cars with OM642 and OM651
Reason for change Steps reformulated in remedial action section
Complaint: Combination message in IC: "Clean fuel filter" is displayed.
The fault code 162500 (water level message - Delphi) or P2226997 (water level message - Bosch) or 171600 (filter load - Bosch) Cause: -
Remedy:
With FC 162500 or FCP226997:
1. Drain water from the fuel filter: Drain off approx. 200 ml (not possible with Q16 - the filter must be changed in this case).
2. After approx. 1 min, at least 50 ml of water must settle at the bottom of the measuring cup - in this case, the message was justified - delete the
FC and hand over the vehicle to the customer.
3. If no water settles in the measuring cup, the message was due to incorrect detection.
4. Check the contacts at the fuel filter/glow time control unit and cable set for moisture.
5. Delete the FC and run the engine at idle for 2 min. Please observe whether the combination message is set again.
6. If the combination message does not occur, please hand the vehicle back over to the customer.
7. If the combination message is set again, please change the fuel filter.
8. Delete the FC and run the engine at idle for 2 min. Please observe whether the combination message is set again.
9. If the combination message is set again, please replace the glow time control unit.
With FC171600:
1. Measure the pressure drop at the filter using 2 pressure gauges.
2. If the pressure drop is greater than 0.7 bar, change the fuel filter.
Symptoms
2010 Mercedes Benz Truck GL 350 BLUETEC (164.825) V6-3.0L DSL Turbo (642.820)
Control unit/fault code
Mercedes-Benz, Luxury Automobiles, German Engineering, Premium Car Brand, Mercedes Innovation
Sunday, June 12, 2016
Fuel System - 'Clean Fuel Filter' Mssg. And DTC's Stored
Popular Posts
-
Part 1 No CAN message was received from control unit Engine management. Possible cause: Fault in CAN communication with control...
-
P179A77 The redundancy system for DIRECT SELECT has a malfunction. The commanded position cannot be reached. Possible cause: A80 (Inte...
-
P2505 Relay 'Circuit 87' ( Engine ) (P2505) Possible cause: N3/10 (MESFI [ME] control unit) K40/4kK (Engine electronics an...
-
Are you a gangster? It seems unlikely. They don鈥檛 subscribe to weekly car magazines, or if they do, they don鈥檛 enter into much correspondenc...
-
2010 Mercedes Benz Truck GL 350 BLUETEC (164.825) V6-3.0L DSL Turbo (642.820) Vehicle: All Technical Service Bulletins Engine - Traces Of ...
-
2010 Cadillac CTS Sedan AWD V6-3.6L Page 71 瀚慖f not the specified value, test the circuit for a short to ground. If the circuit tests normal...
-
Charging a Tesla battery from 0% to 100% depends on the charger type, battery size, and conditions , but here’s a detailed breakdown: 🔋 C...
-
Misfiring of cylinder 5 : Damages TWC (P0305) Misfiring of cylinder 5 : Damages TWC (P0305) Possible cause: Combustion misfirings Aff...
-
When Acura unveiled the new TSX to the public it became the car maker's second model, after the RL, to be criticized for the controversi...
Popular Posts
-
P179D The redundancy system for DIRECT SELECT was activated. There is a signal above the permissible limit value.2010 Mercedes Benz E 63 A...
-
P2505 Relay 'Circuit 87' ( Engine ) (P2505) Possible cause: N3/10 (MESFI [ME] control unit) K40/4kK (Engine electronics an...
-
C426 Start enable 'Drive authorization system' not issued. Possible cause: Engine management Affected functions: ...
-
Misfiring of cylinder 4 : Damages TWC (P0304) Misfiring of cylinder 4 : Damages TWC (P0304) Possible cause: Combustion misfirings Aff...
-
Part 1 One or more messages from control unit N80 (Steering column module) are not available on the CAN bus. Possible cause: Ch...
-
2010 Mercedes Benz Truck GL 350 BLUETEC (164.825) V6-3.0L DSL Turbo (642.820) Vehicle: All Technical Service Bulletins COMAND(R) - 'Dr...
-
2010 Mercedes Benz C 63 AMG Sedan (204.077) V8-6.3L (156.985) Vehicle: Customer Interest ABS/TCS - ABS Lamp ON/Codes 5603/5410 Set Y...
-
P179A77 The redundancy system for DIRECT SELECT has a malfunction. The commanded position cannot be reached. Possible cause: A80 (Inte...
-
D138 The message from the auxiliary oil pump is not available on the CAN bus. Possible cause: M42 (Electric transmission oil ...
-
P0108 B28 (Pressure sensor) : Short circuit to positive or open circuit (P0108) Possible cause: B28 (Pressure sensor) Affected functi...
Popular Posts
-
P179D The redundancy system for DIRECT SELECT was activated. There is a signal above the permissible limit value.2010 Mercedes Benz E 63 A...
-
D138 The message from the auxiliary oil pump is not available on the CAN bus. Possible cause: M42 (Electric transmission oil ...
-
BMW (Benz-Wesbach) is a well-known and respected luxury brand in the European automotive market, particularly for sports cars like the M5. ...
-
Vehicle: All Technical Service Bulletins Diesel Engine - Crackling/Ticking Noise At Idle Engine makes intermittent knocking noise, ticking...
-
P179A77 The redundancy system for DIRECT SELECT has a malfunction. The commanded position cannot be reached. Possible cause: A80 (Inte...
-
Mercedes-Benz Mercedes Benz OEM Parts Mercedes Benz OE Replacement Parts Technical Service Bulletin # LI83-30_P-05363...
-
Okay, so I need to figure out the financial results for Tesla's second quarter of 2025 based on the information provided. Let me start...