Software
Vehicle: All Technical Service Bulletins
Campaign - Update Control Module Software
Campaign No. 2012120002
April 2013
Revision Date Purpose
A 04/05/13 Revision to work Procedure
- 03/28/13 Initial release
TO:
ALL MERCEDES-BENZ CENTERS
SUBJECT:
Model 906, Model Years 2010 - 2011
Update Engine Control Module Software
This Service Campaign has been initiated because Daimler AG (DAG), the manufacturer of Mercedes-Benz and Freightliner Sprinter vehicles, has
determined that humidity can enter the exhaust gas recirculation (EGR) valve which may cause an electrical short circuit. As a result, the feedback
signal from the valve to the engine control module (ECM) may fail. As a consequence, the EGR valve may be switched-off and the vehicles will experience a loss of power and enter a limp home mode. In addition, certain software parameters in the ECM may not respond properly to brief control deviations of the EGR valve position. Under certain circumstances, this ECM programming can cause an unfavorable response which can
deactivate the periodic cleaning function of the EGR valve. If the control deviation occurs twice within two consecutive driving cycles the MIL will
be illuminated. To correct these conditions, Dealers will update the Engine Control Module software at the next workshop visit.
Prior to performing this Service Campaign:
^ Please check VMI to determine if the vehicle is involved in the Campaign and if it has been previously repaired.
^ Please review the entire Service Campaign bulletin and follow the repair procedure exactly as described.
Please note that Recall and Service Campaigns do not expire and may also be performed on a vehicle with a vehicle status indicator.
Approximately 23,122 vehicles are affected.
Procedure
Note :
^ Use DAS/Xentry 11/12 with all associated patches (ensure the following add-ons are included: 2584, 2590, 2651, 2666); or
DAS/Xentry 01/13 or higher with all associated patches (ensure the following add-ons are included: 2675, 2677); or
11/12 release of Fleet Shell (FedEx(R) and other large fleets only)
^ Follow the steps exactly as described in DAS/Xentry.
^ Connect battery charger (battery voltage >12.5V).
^ In the event of software/SCN update issues, contact Star Diagnosis User Help Desk.
^ Refer to Star Diagnosis System (SDS) Best Practices Guide
A. Check for Mobility Lift and PSM
1. Check for mobility lift: If yes proceed to step 2. If no proceed to Subject B.
2. Check for original equipment PSM (option code SA ED5): If yes proceed to Subject B. If no do not update engine control module software, refer
to: LI27.60-N-056078.
B. Update Engine Control Module Software
1. Connect Star Diagnosis to vehicle.
2. Install SCR control unit software: Control units / Drive / SCR control unit Adblue / Control unit adaptations / Control module programming
-----------------------------------------------------Page 1-----------------------------------------------------
2010 Mercedes Benz Truck Sprinter 2500 Crew (906.733) V6-3.0L DSL Turbo (642.898) Copyright ?2013, ALLDATA 10.52SS
Page 2
3. Perform programming of CDI control module: Control units / Drive / CDI 6 common rail injection / Control unit adaptations / Control module
programming.
4. Follow on-screen instructions.
5. Check fault memory: If fault memory16CE00 and/or 16CF00 is present, delete it by pressing the F9 button.
Note :
^ After updating SCR software, the software status should be: 07.37.00
^ After updating CDI software, the software status should be: 12.14.00
Warranty Information
-----------------------------------------------------Page 2-----------------------------------------------------
