2010 Mercedes Benz Truck GL 350 BLUETEC (164.825) V6-3.0L DSL Turbo (642.820)
Vehicle: All Technical Service Bulletins
Suspension - Grunt/Creak Sound From Area Of Front Axle
Grunting/creaking noises from area of front axle
Themen-Nummer LI33.15-P-050245
Version 2
Konstruktionsgruppe 33.15 Axle links
Stand 08-17-2012
Gultigkeit Model 164/251
Anderungsgrund Content and parts attachedment revised
Beanstandung:
Grunting/creaking noises from the area of the front axle when braking, driving over surface undulations, negotiating tight corners, or while
maneuvering at low speeds.
Anhange
Ursache:
Cause 1: Bolt torque connecting the crash strut with the undenfloor (M10 bolt) too low, see "Bild 1.pdf" in attachment.
Cause 2: Bump stop of rear rubber mount comes into contact with external shell.
Cause 3: End faces of front rubber mounts rub against the body and cause noises during certain movements of the transverse control arms.
Anhange
Abhilfe:
Perform a test drive and use e.g. the Steelman Chassis Ear to locate the source of the noise and identify the relevant cause.
If the source cannot be clearly identified, work through the following measures individually. The note (see below) must be observed!
1.) Clean M10 bolt on crash strut and install using a thread locking agent (e.g. Loctite 270).
Tighten bolt to the increased torque of 80 Nm.
Refer to reference sound file 1.mp3
2.) Completely wax rear rubber mount of lower transverse control arm.
Refer to reference sound file 3.mp3
3.) Replace rubber mounts of upper transverse control arms.
4.) Replace front rubber mount of lower transverse control arm.
Refer to reference sound file 2.mp3
Note
^ A test drive must be performed after completing each individual step of the remedy. If the noise is no longer reproducible no further
remedial action should be taken.
^ A new repair method has been defined according to which both rubber mounts of the upper transverse control arm and the front rubber
mount of the lower transverse control arm are replaced separately.
Symptome
Teile
WIS-Referenzen
Attachment
Mercedes-Benz, Luxury Automobiles, German Engineering, Premium Car Brand, Mercedes Innovation
Popular Posts
-
Love For Cars The 2008 model may not look too different to the previous Accord, but under the surface, it is indeed all-new. The styling isn...
-
P179A77 The redundancy system for DIRECT SELECT has a malfunction. The commanded position cannot be reached. Possible cause: A80 (Inte...
-
Vehicle: All Technical Service Bulletins Diesel Engine - Crackling/Ticking Noise At Idle Engine makes intermittent knocking noise, ticking...
-
$102.25 End Date: Sunday Jul-28-2019 13:37:55 PDT Buy It Now for only: $102.25 Buy It Now | Add to watch list
-
$75.97 End Date: Sunday Jul-7-2019 11:44:55 PDT Buy It Now for only: $75.97 Buy It Now | Add to watch list
-
Bendix TitaniuMetallic2 Brake Pads are completely reformulated with TitaniuMetallic2 blue coating and is more effective during...
-
P0108 B28 (Pressure sensor) : Short circuit to positive or open circuit (P0108) Possible cause: B28 (Pressure sensor) Affected functi...
-
The Dremel 4300-9/64 is a versatile corded rotary tool kit designed for a wide range of applications, making it an excellent choice for DI...
-
As of the latest 2025-2026 Tesla lineup, the cheapest Tesla you can buy new is the **Tesla **Model 3 Standard trim — an entry-level versi...
-
You don't need a supercar to have cool doors. There’s far more to a supercar than something as superficial as a cool pair of doors. But,...
Popular Posts
-
P179D The redundancy system for DIRECT SELECT was activated. There is a signal above the permissible limit value.2010 Mercedes Benz E 63 A...
-
P2505 Relay 'Circuit 87' ( Engine ) (P2505) Possible cause: N3/10 (MESFI [ME] control unit) K40/4kK (Engine electronics an...
-
C426 Start enable 'Drive authorization system' not issued. Possible cause: Engine management Affected functions: ...
-
Misfiring of cylinder 4 : Damages TWC (P0304) Misfiring of cylinder 4 : Damages TWC (P0304) Possible cause: Combustion misfirings Aff...
-
Part 1 One or more messages from control unit N80 (Steering column module) are not available on the CAN bus. Possible cause: Ch...
-
2010 Mercedes Benz Truck GL 350 BLUETEC (164.825) V6-3.0L DSL Turbo (642.820) Vehicle: All Technical Service Bulletins COMAND(R) - 'Dr...
-
2010 Mercedes Benz C 63 AMG Sedan (204.077) V8-6.3L (156.985) Vehicle: Customer Interest ABS/TCS - ABS Lamp ON/Codes 5603/5410 Set Y...
-
D138 The message from the auxiliary oil pump is not available on the CAN bus. Possible cause: M42 (Electric transmission oil ...
-
P179A77 The redundancy system for DIRECT SELECT has a malfunction. The commanded position cannot be reached. Possible cause: A80 (Inte...
-
P0108 B28 (Pressure sensor) : Short circuit to positive or open circuit (P0108) Possible cause: B28 (Pressure sensor) Affected functi...
Popular Posts
-
P179D The redundancy system for DIRECT SELECT was activated. There is a signal above the permissible limit value.2010 Mercedes Benz E 63 A...
-
D138 The message from the auxiliary oil pump is not available on the CAN bus. Possible cause: M42 (Electric transmission oil ...
-
Vehicle: All Technical Service Bulletins Diesel Engine - Crackling/Ticking Noise At Idle Engine makes intermittent knocking noise, ticking...
-
Okay, so I need to figure out the financial results for Tesla's second quarter of 2025 based on the information provided. Let me start...
-
Mercedes-Benz Mercedes Benz OEM Parts Mercedes Benz OE Replacement Parts Technical Service Bulletin # LI83-30_P-05363...
-
P179A77 The redundancy system for DIRECT SELECT has a malfunction. The commanded position cannot be reached. Possible cause: A80 (Inte...
-
Part 1 One or more messages from control unit N80 (Steering column module) are not available on the CAN bus. Possible cause: Ch...