Wednesday, October 11, 2017

Y49/4 (Left camshaft intake solenoid) : Short circuit to positive (P2093)

P2093
Y49/4 (Left camshaft intake solenoid) : Short circuit to positive (P2093)
Possible cause:
Y49/4 (Left camshaft intake solenoid)
Affected functions:


Engine diagnosis
Engine output

Test 1: Check component Y49/4 (Left camshaft intake solenoid).
1. Check component Y49/4 (Left camshaft intake solenoid).
Test 1.1: Test actuation of component Y49/4 (Left camshaft intake solenoid).
Test 1.2: Test current consumption of component Y49/4 (Left camshaft intake solenoid).
1.1. Test actuation of component Y49/4 (Left camshaft intake solenoid).
Test prerequisite
Engine at idle
Vehicle stationary
Coolant temperature > 80? C
Time since engine start> 60 s
Status of relevant actual value:
Temperature of coolant:Warning! Communication with ECU required.
Page 9492010 Mercedes Benz E 63 AMG Sedan (212.077) V8­6.3L (156.985)
Copyright ? 2013, ALLDATA
10.52SS
Note
After the actuation it may be necessary to erase the fault memory!
Proceed to 'Actuation' with F2
1.2. Test current consumption of component Y49/4 (Left camshaft intake solenoid).
Figure legend
A ­ConnectionTest cable 35­pin socket box
001 ­Sockets of component N3/10 (ME­SFI [ME] control unit)
05 ­35­pin socket box
050 ­126­pin socket box
108 ­Test cable 266 589 01 63 00
N3/10 (ME­SFI [ME] control unit)
II 1­63ConnectionTest cable
III 64­126ConnectionTest cable
Warning!


Connection A of test cable 108 may NOT be connected to connection B of the 126­pin socket box (050).
Test sequence
Switch off ignition.
Connect socket box (126­pin) to component N3/10 (ME­SFI [ME] control unit).
Measure direct current with multimeter between sockets [F.4] 100 and [M.48] 48 of the 126­pole socket box tester.
Switch on ignition.
Testing of maximum power consumption may be conducted for no longer than 5 s.Specified value
Amperage[1.0...1.8] A
Question

Is the measurement value OK?
YES
The measurement value is OK.End of test
Page 9502010 Mercedes Benz E 63 AMG Sedan (212.077) V8­6.3L (156.985)
Copyright ? 2013, ALLDATA
10.52SS
NO
The measurement value is not OK.Possible cause and remedy
K40/4f43 (Fuse 43)
Line from component Y49/4 (Left camshaft intake solenoid) to component Z7/35 (Circuit 87 M1e connector sleeve)
Line from component Y49/4 (Left camshaft intake solenoid) to component N3/10 (ME­SFI [ME] control unit)
Y49/4 (Left camshaft intake solenoid)
End of test