2010 Mercedes
Benz C 63 AMG Sedan (204.077) V8-6.3L (156.985)
Vehicle: Customer Interest
Instruments - Electric Folding Outside Mirror Noise
ELECTRIC FOLDING OUTSIDE MIRROR MAKES NOISES WHILE OR AFTER EXTENDING OR
RETRACTING
Topic Number LI88.70-P-047993
Version 1
Design Group 88.70 Exterior mirrors
Date 09-24-2009
Validity Model series 204 up to VIN A 292 622 with code 500
Model series 204 up to VIN F 347 207 with code 500 Model series 204 up to VIN
R 082 306 with code 500
Reason for change
Reason for block
Complaint:
Complaint # 1:
Up to 15.10.2008 with code 500 (for identification, see attachment 2)
At cold temperatures (< 15°C), the electric folding outside mirror (code
500) makes creaking noises during the folding sequence.
Complaint # 2:
The electric folding outside mirror (code 500) sporadically makes a
persistent whistling noise after reaching the end position for a short time.
Attachments
Cause:
Cause of complaint # 1:
Material paring between coil spring and underside of sliding disk of folding
mechanism (see attachment 1)
Cause of complaint # 2:
Brush position of electric motor.
Attachments
Remedy:
Remedy for complaint # 1:
- Please note: In the event of complaints, repair both outside mirrors!
1. Remove outside mirror trim (see WIS references).
2. Grease clawed disk in area of slots (see attachment 1).
3. Drill hole (diameter 3 mm) at a height of 3 cm (see attachment 3).
4. Grease the sliding disk. It must be greased with the outside mirror in
three positions (folded in, intermediate position and folded out => see
attachments 4 and 5).
5. operate outside mirrors electrically several times (approx. 8 times).
6. Install outside mirror trim (see WIS references).
Remedy for complaint # 2:
1) Reduce energizing time (actuation period) of outside mirrors to 4 s via
Xentry Diagnostics (not DAS).
-----------------------------------------------------Page
1-----------------------------------------------------
2010 Mercedes
Benz C 63 AMG Sedan (204.077) V8-6.3L (156.985)
Xentry Diagnostics: Door control units - View (DCU-LF-left or right front
door) => Version (DCU-LF - left or right front door) Adaptations =>
Folding in/out of outside mirrors (change of actuation period to 4 s).
NOTE:
Reducing the actuation period to 4 s eliminates 80% of complaints.
2) In vehicles still suffering from complaints after the actuation period is
reduced to 4 s, install the mirror frame (frame) with noise-optimized
folding drive 9see parts)
General Information:
In vehicles without code 275 (Memory package), the mirror motor (see Parts)
must also be ordered when replacing the mirror frame, as described in
the EPC; - P
*Sufficient for 2 cars, submit as Local Purchase - AFS01294, Qty 1, handling
is included
Attachments
Symptoms
Parts
Work units
WIS-Reference
Validity
Attachment 2: Identification/Production date outside mirror, model series
204
Attachment 1: Cause material paring between coil spring and sliding disk
Attachment 3: Repair solution - Drilling
Attachment 4: Repair solution - Greasing 1
Attachment 5: Repair solution - Greasing 2
-----------------------------------------------------Page
2-----------------------------------------------------
Mercedes Benz Diagnostic and Repair Information ,Wiring Diagrams. DTC. TSB. Types: TSB, DTC, Wiring Diagrams, OEM Procedures. Trusted by more than 400,000 technicians. OEM accurate fix for faster repairs. Repair Procedures and Labor Times. Factory Auto Repair info. Request A Demo Today. Factory-Correct Diagrams. Factory Part Numbers. Maintenance Schedules. Repair Procedures. Labor Times. Types: TSB, DTC.Mercedes,Mercedes,Benz,Mercedes-Benz UK,A,Class,B,Class,C,Class,E,Class,CLA,CLS,G,Class,GLA,A
Saturday, February 13, 2016
Instruments - Electric Folding Outside Mirror Noise Mercedes Benz C 63 AMG Sedan (204.077) V8-6.3L (156.985)
Popular Posts
-
D138 The message from the auxiliary oil pump is not available on the CAN bus. Possible cause: M42 (Electric transmission oil ...
-
P179A77 The redundancy system for DIRECT SELECT has a malfunction. The commanded position cannot be reached. Possible cause: A80 (Inte...
-
$369.96 End Date: Sunday Jul-7-2019 10:07:39 PDT Buy It Now for only: $369.96 Buy It Now | Add to watch list
-
$250.95 End Date: Wednesday Jul-24-2019 15:08:29 PDT Buy It Now for only: $250.95 Buy It Now | Add to watch list
-
Okay, these are OBD-II trouble codes related specifically to issues with the **Downstream Oxygen Sensors** in your vehicle's exhaust sys...
-
In 2026, the reliability landscape for Tesla and Polestar has shifted. While Tesla has historically struggled with "fit and finish,...
-
2010 Cadillac Truck Escalade RWD V8-6.2L Page 1643 * Observe the DTC information with a scan tool. Verify there are no B52 HO2S heater or fu...
-
P2505 Relay 'Circuit 87' ( Engine ) (P2505) Possible cause: N3/10 (MESFI [ME] control unit) K40/4kK (Engine electronics an...
-
P179C09 Control unit 'DIRECT SELECT' has a malfunction. There is a component fault. Possible cause: A80 (Intelligent servo mod...
Popular Posts
-
P179D The redundancy system for DIRECT SELECT was activated. There is a signal above the permissible limit value.2010 Mercedes Benz E 63 A...
-
P2505 Relay 'Circuit 87' ( Engine ) (P2505) Possible cause: N3/10 (MESFI [ME] control unit) K40/4kK (Engine electronics an...
-
C426 Start enable 'Drive authorization system' not issued. Possible cause: Engine management Affected functions: ...
-
Misfiring of cylinder 4 : Damages TWC (P0304) Misfiring of cylinder 4 : Damages TWC (P0304) Possible cause: Combustion misfirings Aff...
-
Part 1 One or more messages from control unit N80 (Steering column module) are not available on the CAN bus. Possible cause: Ch...
-
2010 Mercedes Benz Truck GL 350 BLUETEC (164.825) V6-3.0L DSL Turbo (642.820) Vehicle: All Technical Service Bulletins COMAND(R) - 'Dr...
-
2010 Mercedes Benz C 63 AMG Sedan (204.077) V8-6.3L (156.985) Vehicle: Customer Interest ABS/TCS - ABS Lamp ON/Codes 5603/5410 Set Y...
-
P179A77 The redundancy system for DIRECT SELECT has a malfunction. The commanded position cannot be reached. Possible cause: A80 (Inte...
-
D138 The message from the auxiliary oil pump is not available on the CAN bus. Possible cause: M42 (Electric transmission oil ...
-
P0108 B28 (Pressure sensor) : Short circuit to positive or open circuit (P0108) Possible cause: B28 (Pressure sensor) Affected functi...
Popular Posts
-
P179D The redundancy system for DIRECT SELECT was activated. There is a signal above the permissible limit value.2010 Mercedes Benz E 63 A...
-
D138 The message from the auxiliary oil pump is not available on the CAN bus. Possible cause: M42 (Electric transmission oil ...
-
Vehicle: All Technical Service Bulletins Diesel Engine - Crackling/Ticking Noise At Idle Engine makes intermittent knocking noise, ticking...
-
BMW (Benz-Wesbach) is a well-known and respected luxury brand in the European automotive market, particularly for sports cars like the M5. ...
-
P179A77 The redundancy system for DIRECT SELECT has a malfunction. The commanded position cannot be reached. Possible cause: A80 (Inte...
-
The Dremel 4300-9/64 is a versatile corded rotary tool kit designed for a wide range of applications, making it an excellent choice for DI...
-
Mercedes-Benz Mercedes Benz OEM Parts Mercedes Benz OE Replacement Parts Technical Service Bulletin # LI83-30_P-05363...
-
P179C09 Control unit 'DIRECT SELECT' has a malfunction. There is a component fault. Possible cause: A80 (Intelligent servo mod...
-
Okay, so I need to figure out the financial results for Tesla's second quarter of 2025 based on the information provided. Let me start...