2010 Mercedes
Benz C 63 AMG Sedan (204.077) V8-6.3L (156.985)
Vehicle: Customer Interest
ABS/TCS - 'Unavailable ESP/ABS/TPMS' Appears
Message in instrument cluster "Unavailable! - ESP - See operator's
manual!"
Topic number LI42.47-P-049297
Version 1
Design group 42.47 Adaptive Brake (ABR)
Date 04-06-2010
Validity Model series 204
Reason for change
Reason for block
Complaint:
The following messages appear alternately in the instrument cluster:
- "Unavailable! - ESP - See operator's manual!"
- "Unavailable! - ABS - See operator's manual!"
- "Tire pressure monitor unavailable"
Note:
In the ESP control unit ((N30-4) (ESP-CU)) the codes:
- 5102 and/or
- 5112 and/or
- 5122 and/or
- 5132 and/or
- 7271 and/or
- 7270
may be stored.
Cause:
The above codes are logged during the start-off monitoring of the wheel rpm
sensors (DZS).
This monitoring is active even when ESP is OFF.
Under gentle acceleration via the accelerator pedal in ESP OFF mode, one of
the driven wheels may start to spin slowly due to slip (e.g. on ice or if
contact with the ground is lost). If this wheel reaches a speed in excess of
15 km/h and the speed of all other wheels is less than 6 km/h, the ESP
control unit logs an appropriate code for these rpm sensors. If the
acceleration command is increased (in an attempt to gain grip), the relevant
code
(51x2) is logged after 180 seconds.
In the next ignition sequence when the vehicle speed exceeds 10 km/h the ESP
control unit checks whether the display in the instrument cluster is
still relevant. If there are no other codes logged for the rpm sensor, the
ABS and ESP systems are available again.
Note:
In ESP ON mode the overspinning wheel is braked when it reaches a speed of 15
km/h.
Remedy:
Erase codes.
It is not necessary to replace any parts.
-----------------------------------------------------Page
1-----------------------------------------------------
2010 Mercedes
Benz C 63 AMG Sedan (204.077) V8-6.3L (156.985)
Symptoms
Control unit/fault code
Validity
-----------------------------------------------------Page
2-----------------------------------------------------
Mercedes-Benz, Luxury Automobiles, German Engineering, Premium Car Brand, Mercedes Innovation
Saturday, February 13, 2016
ABS/TCS - 'Unavailable ESP/ABS/TPMS' Appears Mercedes Benz C 63 AMG Sedan (204.077) V8-6.3L (156.985)
Subscribe to:
Post Comments (Atom)
Popular Posts
-
Part 1 No CAN message was received from control unit Engine management. Possible cause: Fault in CAN communication with control...
-
P179A77 The redundancy system for DIRECT SELECT has a malfunction. The commanded position cannot be reached. Possible cause: A80 (Inte...
-
P2505 Relay 'Circuit 87' ( Engine ) (P2505) Possible cause: N3/10 (MESFI [ME] control unit) K40/4kK (Engine electronics an...
-
Are you a gangster? It seems unlikely. They don鈥檛 subscribe to weekly car magazines, or if they do, they don鈥檛 enter into much correspondenc...
-
2010 Mercedes Benz Truck GL 350 BLUETEC (164.825) V6-3.0L DSL Turbo (642.820) Vehicle: All Technical Service Bulletins Engine - Traces Of ...
-
2010 Cadillac CTS Sedan AWD V6-3.6L Page 71 瀚慖f not the specified value, test the circuit for a short to ground. If the circuit tests normal...
-
Charging a Tesla battery from 0% to 100% depends on the charger type, battery size, and conditions , but here’s a detailed breakdown: 🔋 C...
-
Misfiring of cylinder 5 : Damages TWC (P0305) Misfiring of cylinder 5 : Damages TWC (P0305) Possible cause: Combustion misfirings Aff...
-
When Acura unveiled the new TSX to the public it became the car maker's second model, after the RL, to be criticized for the controversi...
Popular Posts
-
P179D The redundancy system for DIRECT SELECT was activated. There is a signal above the permissible limit value.2010 Mercedes Benz E 63 A...
-
P2505 Relay 'Circuit 87' ( Engine ) (P2505) Possible cause: N3/10 (MESFI [ME] control unit) K40/4kK (Engine electronics an...
-
C426 Start enable 'Drive authorization system' not issued. Possible cause: Engine management Affected functions: ...
-
Misfiring of cylinder 4 : Damages TWC (P0304) Misfiring of cylinder 4 : Damages TWC (P0304) Possible cause: Combustion misfirings Aff...
-
Part 1 One or more messages from control unit N80 (Steering column module) are not available on the CAN bus. Possible cause: Ch...
-
2010 Mercedes Benz Truck GL 350 BLUETEC (164.825) V6-3.0L DSL Turbo (642.820) Vehicle: All Technical Service Bulletins COMAND(R) - 'Dr...
-
2010 Mercedes Benz C 63 AMG Sedan (204.077) V8-6.3L (156.985) Vehicle: Customer Interest ABS/TCS - ABS Lamp ON/Codes 5603/5410 Set Y...
-
P179A77 The redundancy system for DIRECT SELECT has a malfunction. The commanded position cannot be reached. Possible cause: A80 (Inte...
-
D138 The message from the auxiliary oil pump is not available on the CAN bus. Possible cause: M42 (Electric transmission oil ...
-
P0108 B28 (Pressure sensor) : Short circuit to positive or open circuit (P0108) Possible cause: B28 (Pressure sensor) Affected functi...
Popular Posts
-
P179D The redundancy system for DIRECT SELECT was activated. There is a signal above the permissible limit value.2010 Mercedes Benz E 63 A...
-
D138 The message from the auxiliary oil pump is not available on the CAN bus. Possible cause: M42 (Electric transmission oil ...
-
BMW (Benz-Wesbach) is a well-known and respected luxury brand in the European automotive market, particularly for sports cars like the M5. ...
-
Vehicle: All Technical Service Bulletins Diesel Engine - Crackling/Ticking Noise At Idle Engine makes intermittent knocking noise, ticking...
-
P179A77 The redundancy system for DIRECT SELECT has a malfunction. The commanded position cannot be reached. Possible cause: A80 (Inte...
-
Mercedes-Benz Mercedes Benz OEM Parts Mercedes Benz OE Replacement Parts Technical Service Bulletin # LI83-30_P-05363...
-
Okay, so I need to figure out the financial results for Tesla's second quarter of 2025 based on the information provided. Let me start...
No comments:
Post a Comment