2010 Cadillac Truck SRX FWD V6-3.0L Page 1687

2010 Cadillac Truck SRX FWD V6-3.0L Page 1687

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Description and Operation

Transmission Component and System Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and

Operation/AF40-6 - Automatic Transmission/Transmission Component and System Description)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

1. Engine idling, observe the scan tool Transmission ISS parameter while varying the engine speed. The Transmission ISS parameter should

change with the engine speed and not drop out.

2. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the

conditions you observed from the Freeze Frame/Failure Records data.

Circuit/System Testing

Static Test

1. Ignition OFF, remove the K71 Transmission Control Module.

2. Test for more than 1 Mohm between the low reference circuit terminal 13 X2 and the voltage supply circuit terminal 12 X2.

瀚慖f less than the specified range, test the wiring harness for internal short. If the circuit tests normal, replace the automatic transmission.

3. Test for infinite resistance between each terminal and the low reference circuit terminal 13 X2 and also to the voltage supply circuit terminal

12 X2.

瀚慖f less than the specified range, replace the wiring harness.

4. If all circuits test normal, test or replace the K71 Transmission Control Module. Verify the DTC does not reset.

瀚慖f the DTC resets, replace the automatic transmission.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Automatic transmission replacement-Refer to Transmission Replacement ().

* Control valve body-Refer to Control Valve Body Replacement (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Valve

Body/Service and Repair/AF40-6 - Automatic Transmission/Control Valve Body Replacement) for replacement.

* Wiring harness-Refer to Automatic Transmission Wiring Harness Replacement (See: Transmission and Drivetrain/Automatic

Transmission/Transaxle/Wiring Harness/Service and Repair) for replacement.

* TCM-Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for replacement, setup and

programming.

* Perform the Transmission Adaptive Functions (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and

Operation/AF40-6 - Automatic Transmission/Transmission Adaptive Functions).

6T70/6T75 - Automatic Transmission

DTC P0722 or P0723

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.