2010 Cadillac CTS Sedan AWD V6-3.6L Page 71
瀚慖f not the specified value, test the circuit for a short to ground. If the circuit tests normal, replace the pedestrian impact detection module.
5. Test for infinite resistance between the low control circuit terminal B and ground.
瀚慖f not the specified value, test the circuit for a short to ground. If the circuit tests normal, replace the pedestrian impact detection module.
6. Test for less then 1 ohm between the high control circuit terminal A and ground.
瀚慖f not within the specified range, test the circuit for an open/high resistance.
7. Test for less then 1 ohm between the low control circuit terminal B and ground.
瀚慖f not within the specified range, test the circuit for an open/high resistance.
8. If all circuits test normal, replace the right active hood hinge actuator.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Active Hood Hinge Actuator Replacement (See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist
Systems/Service and Repair/Removal and Replacement)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for pedestrian impact detection module
replacement, setup, and programming
B009C
DTC B009C
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
B009C 01
- Pedestrian Impact Detection Discrimination Sensor Short to Battery
B009C 02
- Pedestrian Impact Detection Discrimination Sensor Short to Ground
B009C 08
- Pedestrian Impact Detection Discrimination Sensor Signal Invalid/Open Circuit
B009C 39
- Pedestrian Impact Detection Discrimination Sensor Internal Electronic Failure
B009C 3A
- Pedestrian Impact Detection Discrimination Sensor Incorrect Component Installed
Diagnostic Fault Information
No comments:
Post a Comment