2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1767
4. Install a 3 A fused jumper wire between the signal circuit terminal B and the low reference circuit terminal A. Verify the scan tool ECT
parameter is greater than 149掳C (300掳F).
瀚慖f less than the specified range, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace
the K20 ECM.
5. If all circuits test normal, test or replace the B34 ECT sensor.
Component Testing
Measure and record the resistance of the ECT sensor at various ambient temperatures, then compare those measurements to the Temperature vs
Resistance table. Refer to Temperature Versus Resistance (See: Powertrain Management/Computers and Control
Systems/Specifications/Temperature Versus Resistance).
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Engine Coolant Temperature Sensor Replacement (See: Engine, Cooling and Exhaust/Cooling System/Engine - Coolant Temperature
Sensor/Switch/Coolant Temperature Sensor/Switch (For Computer)/Service and Repair)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup, and programming
P0118
DTC P0117 or P0118 (Without L96)
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P0117
- Engine Coolant Temperature (ECT) Sensor Circuit Low Voltage
DTC P0118
- Engine Coolant Temperature (ECT) Sensor Circuit High Voltage
Diagnostic Fault Information
Typical Scan Tool Data
Circuit/System Description
The engine coolant temperature (ECT) sensor is a variable resistor that measures the temperature of the engine coolant. The engine control module
(ECM) supplies 5 V to the ECT signal circuit and supplies a ground to the low reference circuit.
Conditions for Running the DTC
No comments:
Post a Comment