Saturday, October 31, 2020

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1619

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1619



5. Inspect the machined teeth on the 1-2-3-4 and 3-5 clutch housing outer surface for damage or misalignment. Repair or replace as necessary.



6. If all of the above test normal, replace the B14A/B14C ISS/OSS assembly.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Perform the Input and Output Speed Sensor Replacement (See: Powertrain Management/Transmission Control Systems/Sensors and



Switches - Transmission and Drivetrain/Sensors and Switches - A/T/Transmission Speed Sensor/Service and Repair).



* Control solenoid valve assembly - refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for



replacement, setup, and programming.



* Perform the Control Solenoid Valve and Transmission Control Module Assembly Input Shaft Speed/Output Shaft Speed Input Test (See:



Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Component Tests and General Diagnostics/Control



Solenoid Valve and Transmission Control Module Assembly Input Shaft Speed/Output Shaft Speed Input Test).



* Perform the Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and



Inspection/Programming and Relearning/Service Fast Learn Adapts) following all transmission related repairs.



P0717



DTC P0716 or P0717



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P0716



- Input Speed Sensor Performance



DTC P0717



- Input Speed Sensor Circuit Low Voltage



Diagnostic Fault Information



Typical Scan Tool Data



Circuit/System Description



The automatic transmission (AT) input and output speed sensor (ISS and OSS) assembly each are part of a single harness. The ISS is a hall-effect



type sensor. The ISS/OSS mounts to the control valve upper body assembly. The ISS sensor end faces the splines on the 1-2-3-4 and 3-5-R clutch



housing outside diameter surface. The sensor receives 8.3-9.3 volts on the ISS/OSS supply voltage circuit from the control solenoid valve



assembly. As the 1-2-3-4 and 3-5-R clutch housing rotates, the sensor produces a signal frequency based on the splines on the clutch housing



outside diameter surface. This signal is transmitted through the ISS signal circuit to the control solenoid valve assembly. The control solenoid valve



assembly uses the ISS signal to determine line pressure, transmission shift patterns, torque converter clutch (TCC) slip speed and gear ratio.

No comments:

Post a Comment