2010 Cadillac Truck SRX AWD V6-3.0L Page 682

2010 Cadillac Truck SRX AWD V6-3.0L Page 682

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Radio Control Switch Replacement - Steering Wheel (See: Accessories and Optional Equipment/Radio, Stereo, and Compact

Disc/Radio/Stereo/Service and Repair/Radio Control Switch Replacement - Steering Wheel)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup, and programming

B3650

DTC B3650

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions)provides an overview of each diagnostic category.

DTC Descriptor

DTC B3650 08

- High Beam Request Signal Circuit Performance - Signal Invalid

Diagnostic Fault Information

Circuit/System Description

The BCM monitors the voltage level within the high beam signal circuit and the flash to pass signal circuit. When the turn signal/multifunction

switch is moved to the high beam position or to the flash to pass position, the voltage within the appropriate signal circuit drops to less than 1 V.

The BCM will detect the voltage drop and will command the headlamp high beams to turn ON or OFF.

Conditions for Running the DTC

Battery voltage must be between 9-16 V.

Conditions for Setting the DTC

The BCM detects a short to ground in the headlamp high beam signal circuit.

Action Taken When the DTC Sets

The high beam headlamps will malfunction.

Conditions for Clearing the DTC

* The DTC will be current for as long as the fault is present.

* When the fault is no longer present, the DTC will be a history DTC.

* A history DTC will clear after 50 ignition cycles.