2010 Cadillac CTS Sedan AWD V6-3.0L Page 1610
Communication codes, U-codes, as well as powertrain codes, P-codes, set in the TCM can cause the TCM to request DTC P0700 to be set in the
ECM.
Reference Information
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code
(DTC) Type Definitions)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning)
Circuit/System Verification
Note: Correct any engine controls and communication DTCs before diagnosing TCM DTCs.
1. DTC P0700 is an informational DTC. If there are no engine controls or communication DTCs, refer to Diagnostic Trouble Code (DTC) List -
Vehicle (See: Diagnostic Trouble Code Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle) for diagnosis of TCM DTCs.
2. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the
conditions that you observed from the Freeze Frame/Failure Records data.
P0711
DTC P0711, P0712, or P0713
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P0711
- Transmission Fluid Temperature (TFT) Sensor Performance
DTC P0712
- Transmission Fluid Temperature (TFT) Sensor Circuit Low Voltage
DTC P0713
- Transmission Fluid Temperature (TFT) Sensor Circuit High Voltage
Circuit/System Description
The transmission fluid temperature (TFT) sensor is located inside of the transmission control module (TCM) assembly which has no serviceable
parts. The TFT sensor provides transmission fluid temperature to the TCM. This fault is handled inside the TCM and no external circuits are
involved.
Conditions for Running the DTC
P0711
* DTCs P0101, P0102, P0103, P0116, P0117, P0118, P0121, P0122, P0123, P0336, P0337, P0338, P0711, P0716, P0722, P0723, P0742, or
P2726 are not set.
* Ignition voltage is 8.6 volts or greater.
* The engine coolant temperature (ECT) is valid.
* The TCM internal temperature is -50掳C to +170掳C (-56掳F and +336掳F) at start up.
* The engine speed is 500 RPM or greater for 5 seconds.
* The vehicle speed is 8 km/h (5 mph) or greater for 5 minutes.
* The engine coolant temperature is between -39掳C and 149掳C (-38掳F and 300掳F).
* The accelerator pedal position signal is valid.
* The engine torque signal is valid.
P0712 or P0713
* DTCs P0712, P0713, P0716, P0717, P0722, or P0723 are not set.
* Ignition voltage is 8.6 volts or greater.
No comments:
Post a Comment