2010 Mercedes
Benz C 63 AMG Sedan (204.077) V8-6.3L (156.985)
Vehicle: Customer Interest
Wipers/Washers - 'Low Washer Fluid Level' Warning
WASHER FLUID INDICATOR ON INSTRUMENT CLUSTER INCORRECT
Topic number LI82.35-P-048244
Version 1
Design group 82.35 Windshield washing system
Date 10-28-2009
Validity Model 169 with code U58
Model 245 with code U58, Model 204, 216, 212
Model GLK 204, 164, 251, 221
Reason for change Applicable models and remedy updated / Supersedes
DTB P-B-82.35/587 and T-B-82.35/588
Reason for block
Complaint:
Washer fluid indicator is not correct.
Indicator on instrument cluster shows that reservoir is empty although the
reservoir contains sufficient windshield washer fluid.
Cause:
The electrical conductivity of the fluid in the washer fluid reservoir is not
sufficient due to:
a) The use of distilled or deionized water,
b) Tap water content of mixing ratio is too low or
c) Proportion of winter washer fluid concentrate is too high (antifreeze
protection approx.100%)
The electrical circuit cannot be closed by the 2-pin sensor and the message
"Washer fluid reservoir empty" appears in the display of the instrument
cluster.
Remedy:
Fill the reservoir with washer concentrate and tap water at the recommended
mixing ratio (see owner's manual).
Note:
It is assumed that the connectors to the washer fluid level sensor are
plugged in and the lines have no function impairments.
Replacement of the SAM control unit or the current washer fluid level sensor
does not rectify the issue.
Symptoms
Parts
Validity
-----------------------------------------------------Page
1-----------------------------------------------------
Mercedes Benz Diagnostic and Repair Information ,Wiring Diagrams. DTC. TSB. Types: TSB, DTC, Wiring Diagrams, OEM Procedures. Trusted by more than 400,000 technicians. OEM accurate fix for faster repairs. Repair Procedures and Labor Times. Factory Auto Repair info. Request A Demo Today. Factory-Correct Diagrams. Factory Part Numbers. Maintenance Schedules. Repair Procedures. Labor Times. Types: TSB, DTC.Mercedes,Mercedes,Benz,Mercedes-Benz UK,A,Class,B,Class,C,Class,E,Class,CLA,CLS,G,Class,GLA,A
Saturday, February 13, 2016
Wipers/Washers - 'Low Washer Fluid Level' Warning Mercedes Benz C 63 AMG Sedan (204.077)
Popular Posts
-
D138 The message from the auxiliary oil pump is not available on the CAN bus. Possible cause: M42 (Electric transmission oil ...
-
P179A77 The redundancy system for DIRECT SELECT has a malfunction. The commanded position cannot be reached. Possible cause: A80 (Inte...
-
C $38.22 End Date: Saturday Feb-15-2020 2:20:12 EST Buy It Now for only: C $38.22 Buy It Now | Add to watch list
-
$369.96 End Date: Sunday Jul-7-2019 10:07:39 PDT Buy It Now for only: $369.96 Buy It Now | Add to watch list
-
2010 Mercedes Benz C 63 AMG Sedan (204.077) V8-6.3L (156.985) Vehicle: Customer Interest Restraints - (PRE-SAFE) Inactive And DTC 5306...
-
A very good automotive that handles but, to get the identical specs it costs RM75k. Even the 316i which carries a 1.6 isn't any match to...
-
P2505 Relay 'Circuit 87' ( Engine ) (P2505) Possible cause: N3/10 (MESFI [ME] control unit) K40/4kK (Engine electronics an...
-
2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 390 瀚慖f less than the specified range, test the signal circuit for a short to ground or an...
-
P179D The redundancy system for DIRECT SELECT was activated. There is a signal above the permissible limit value.2010 Mercedes Benz E 63 A...
Popular Posts
-
P179D The redundancy system for DIRECT SELECT was activated. There is a signal above the permissible limit value.2010 Mercedes Benz E 63 A...
-
P2505 Relay 'Circuit 87' ( Engine ) (P2505) Possible cause: N3/10 (MESFI [ME] control unit) K40/4kK (Engine electronics an...
-
C426 Start enable 'Drive authorization system' not issued. Possible cause: Engine management Affected functions: ...
-
Misfiring of cylinder 4 : Damages TWC (P0304) Misfiring of cylinder 4 : Damages TWC (P0304) Possible cause: Combustion misfirings Aff...
-
Part 1 One or more messages from control unit N80 (Steering column module) are not available on the CAN bus. Possible cause: Ch...
-
2010 Mercedes Benz Truck GL 350 BLUETEC (164.825) V6-3.0L DSL Turbo (642.820) Vehicle: All Technical Service Bulletins COMAND(R) - 'Dr...
-
2010 Mercedes Benz C 63 AMG Sedan (204.077) V8-6.3L (156.985) Vehicle: Customer Interest ABS/TCS - ABS Lamp ON/Codes 5603/5410 Set Y...
-
P179A77 The redundancy system for DIRECT SELECT has a malfunction. The commanded position cannot be reached. Possible cause: A80 (Inte...
-
D138 The message from the auxiliary oil pump is not available on the CAN bus. Possible cause: M42 (Electric transmission oil ...
-
P0108 B28 (Pressure sensor) : Short circuit to positive or open circuit (P0108) Possible cause: B28 (Pressure sensor) Affected functi...
Popular Posts
-
P179D The redundancy system for DIRECT SELECT was activated. There is a signal above the permissible limit value.2010 Mercedes Benz E 63 A...
-
D138 The message from the auxiliary oil pump is not available on the CAN bus. Possible cause: M42 (Electric transmission oil ...
-
Vehicle: All Technical Service Bulletins Diesel Engine - Crackling/Ticking Noise At Idle Engine makes intermittent knocking noise, ticking...
-
BMW (Benz-Wesbach) is a well-known and respected luxury brand in the European automotive market, particularly for sports cars like the M5. ...
-
P179A77 The redundancy system for DIRECT SELECT has a malfunction. The commanded position cannot be reached. Possible cause: A80 (Inte...
-
The Dremel 4300-9/64 is a versatile corded rotary tool kit designed for a wide range of applications, making it an excellent choice for DI...
-
Mercedes-Benz Mercedes Benz OEM Parts Mercedes Benz OE Replacement Parts Technical Service Bulletin # LI83-30_P-05363...
-
P179C09 Control unit 'DIRECT SELECT' has a malfunction. There is a component fault. Possible cause: A80 (Intelligent servo mod...
-
Okay, so I need to figure out the financial results for Tesla's second quarter of 2025 based on the information provided. Let me start...