Sunday, February 14, 2016

Steering/Starting - No Crank/Start/ESL And ICM Don't Respond Mercedes Benz C 300 4MATIC (204.081) V6-3.0L (272.948)

2010 Mercedes Benz C 300 4MATIC (204.081) V6-3.0L (272.948)

Vehicle: All Technical Service Bulletins

Steering/Starting - No Crank/Start/ESL And ICM Don't Respond

No Crank/No Start/ESL and ICM do not respond to key input

Topic number         LI80.57-P-051521

Version               1

Design group          80.57 Drive authorization systems (DAS)

Date                  06-01-2011

Validity              All 204, 207 model vehicles

Reason for change

Complaint

1.     No crank / no start / intermittent no crank

2.     Communication via SDS to Electronic Ignition Switch N73 (EIS/EZS), and or short test may or may not be possible at time of fault

3.     Below scenario:

^    When accessing the occupants compartment, the message center in the ICM will illuminate (note: eventually the message center will time

out and shut down, and will not illuminate until the CAN is activated via the interior lock/unlock switch).

^    The key will turn in EIS N73.

^    The ESL N26/5 does not activate/respond (or the steering wheel remains unlocked at all times).

^    The warning icons in the ICM will not illuminate.

Cause

Internal issue with in Electronic Steering Lock N26/5 (part number A 204 545 57 32)

Remedy

First perform a complete guided test of the drive authorization system, and transmitter key via the "Tests" menu in the EZS control unit.

Fault codes A25408 and A25464 in the Electronic Ignition Lock N73 (EIS/EZS) direct you to replace the Electronic Steering Lock N26/5.

NOTE:

If no fault codes are stored, do not replace any parts!

Check the part number on the Electronic Steering Lock N26/5. If the part number is A204 545 57 32, please replace with part number A 204 545 81

32 using WIS instructions AR46.10-P-0910CW.

If the part number of the Electronic Steering Lock is A 204 545 81 32, please contact Dealer Technical Support; we would like to have the part

shipped to us for further analysis.

Note:

It is possible to corrupt the Electronic Ignition Switch N73 if it is replaced prior to replacement of the suspect ESL. Also, insure that the CAN does

not time out before the programming of the ESL with the workshop key is completed.

Symptoms

Control unit/fault code

Parts

Operation numbers/damage codes

-----------------------------------------------------Page 1-----------------------------------------------------