2010 Mercedes
Benz C 63 AMG Sedan (204.077) V8-6.3L (156.985)
Vehicle: Customer Interest
Drivetrain - Noises at Full Lock From Front Axle Area
Squeaking noise emanating from area of front axle at full steering lock
Topic number L133.30-P-055908
Version 1
Design group 33.30 Final drive, differential, drive shaft
Date 04-12-2013
Validity Models: All Mercedes-Benz
cars with front-wheel drive
and 4x4 vehicles
Reason for change
Complaint:
Noises (squeaking) at full steering lock from the area of the front axle.
Cause:
The painting of the rubber boot during production can result in a squeaking
noise in the area of the outer joints at full lock.
Remedy:
Raise the vehicle at the front axle, then turn the steering wheel to full
lock on both sides while rotating the wheels by hand. If there is a squeaking
noise near the full lock position, the following work procedure is to be
performed:
1. Clean boots on left and right outer joints.
2. Coat boots on left and right outer joints with lubricant A 000 989 36
60*.
Note :
Do not replace the side shafts on account of this complaint.
Symptoms
Parts
Work units
-----------------------------------------------------Page
1-----------------------------------------------------
Mercedes Benz Diagnostic and Repair Information ,Wiring Diagrams. DTC. TSB. Types: TSB, DTC, Wiring Diagrams, OEM Procedures. Trusted by more than 400,000 technicians. OEM accurate fix for faster repairs. Repair Procedures and Labor Times. Factory Auto Repair info. Request A Demo Today. Factory-Correct Diagrams. Factory Part Numbers. Maintenance Schedules. Repair Procedures. Labor Times. Types: TSB, DTC.Mercedes,Mercedes,Benz,Mercedes-Benz UK,A,Class,B,Class,C,Class,E,Class,CLA,CLS,G,Class,GLA,A
Saturday, February 13, 2016
Drivetrain - Noises at Full Lock From Front Axle Area Mercedes Benz C 63 AMG Sedan (204.077) V8-6.3L (156.985)
Popular Posts
-
D138 The message from the auxiliary oil pump is not available on the CAN bus. Possible cause: M42 (Electric transmission oil ...
-
P179A77 The redundancy system for DIRECT SELECT has a malfunction. The commanded position cannot be reached. Possible cause: A80 (Inte...
-
$369.96 End Date: Sunday Jul-7-2019 10:07:39 PDT Buy It Now for only: $369.96 Buy It Now | Add to watch list
-
$250.95 End Date: Wednesday Jul-24-2019 15:08:29 PDT Buy It Now for only: $250.95 Buy It Now | Add to watch list
-
Okay, these are OBD-II trouble codes related specifically to issues with the **Downstream Oxygen Sensors** in your vehicle's exhaust sys...
-
P2505 Relay 'Circuit 87' ( Engine ) (P2505) Possible cause: N3/10 (MESFI [ME] control unit) K40/4kK (Engine electronics an...
-
In 2026, the reliability landscape for Tesla and Polestar has shifted. While Tesla has historically struggled with "fit and finish,...
-
P0117 B11/4 (Coolant temperature sensor) : Short circuit to ground (P0117) Possible cause: B11/4 (Coolant temperature sensor) R48 (...
Popular Posts
-
P179D The redundancy system for DIRECT SELECT was activated. There is a signal above the permissible limit value.2010 Mercedes Benz E 63 A...
-
P2505 Relay 'Circuit 87' ( Engine ) (P2505) Possible cause: N3/10 (MESFI [ME] control unit) K40/4kK (Engine electronics an...
-
C426 Start enable 'Drive authorization system' not issued. Possible cause: Engine management Affected functions: ...
-
Misfiring of cylinder 4 : Damages TWC (P0304) Misfiring of cylinder 4 : Damages TWC (P0304) Possible cause: Combustion misfirings Aff...
-
Part 1 One or more messages from control unit N80 (Steering column module) are not available on the CAN bus. Possible cause: Ch...
-
2010 Mercedes Benz Truck GL 350 BLUETEC (164.825) V6-3.0L DSL Turbo (642.820) Vehicle: All Technical Service Bulletins COMAND(R) - 'Dr...
-
2010 Mercedes Benz C 63 AMG Sedan (204.077) V8-6.3L (156.985) Vehicle: Customer Interest ABS/TCS - ABS Lamp ON/Codes 5603/5410 Set Y...
-
P179A77 The redundancy system for DIRECT SELECT has a malfunction. The commanded position cannot be reached. Possible cause: A80 (Inte...
-
D138 The message from the auxiliary oil pump is not available on the CAN bus. Possible cause: M42 (Electric transmission oil ...
-
P0108 B28 (Pressure sensor) : Short circuit to positive or open circuit (P0108) Possible cause: B28 (Pressure sensor) Affected functi...
Popular Posts
-
P179D The redundancy system for DIRECT SELECT was activated. There is a signal above the permissible limit value.2010 Mercedes Benz E 63 A...
-
D138 The message from the auxiliary oil pump is not available on the CAN bus. Possible cause: M42 (Electric transmission oil ...
-
Vehicle: All Technical Service Bulletins Diesel Engine - Crackling/Ticking Noise At Idle Engine makes intermittent knocking noise, ticking...
-
BMW (Benz-Wesbach) is a well-known and respected luxury brand in the European automotive market, particularly for sports cars like the M5. ...
-
P179A77 The redundancy system for DIRECT SELECT has a malfunction. The commanded position cannot be reached. Possible cause: A80 (Inte...
-
The Dremel 4300-9/64 is a versatile corded rotary tool kit designed for a wide range of applications, making it an excellent choice for DI...
-
Mercedes-Benz Mercedes Benz OEM Parts Mercedes Benz OE Replacement Parts Technical Service Bulletin # LI83-30_P-05363...
-
P179C09 Control unit 'DIRECT SELECT' has a malfunction. There is a component fault. Possible cause: A80 (Intelligent servo mod...
-
Okay, so I need to figure out the financial results for Tesla's second quarter of 2025 based on the information provided. Let me start...