2010 Mercedes
Benz C 63 AMG Sedan (204.077) V8-6.3L (156.985)
Vehicle: Customer Interest
Computers/Controls - Malfunctions Of Various Power/Control Unit
Malfunctions of various control units and/or on-board power supply problems
caused by water in the control unit tray under the driver/front
passenger seat (dislocated, pinched or leaking condensation hose)
Topic number L183.00-P-052510
Version 2
Design group 83.00 General
Date 02-28-2013
Validity All Mercedes-Benz
cars
Reason for change Remedy adapted, validity adapted
Complaint:
Water that enters into the control unit tray under the driver/front passenger
seat can damage the control units installed there and complaints may be
received about the functions associated with these control units.
Problems with the on-board power supply voltage may also occur.
Cause:
The condensation hose (right/left) on the A/C housing may either be
dislocated, pinched/crushed (water collects in A/C housing) or leaking,
resulting
in water entering the interior.
Remedy:
If the condensation hose (right/left) is dislocated, push it all the way back
onto the outlet fitting of the A/C housing and check for tight seating by
pulling gently. If necessary, use a cable tie to additionally fix the
condensation hose in place. Never use soapy water or silicone spray to
install.
If the condensation hose (right/left) is pinched/crushed, it can be checked
for free passage as follows:
1. Use the operating unit to set maximum cooling on both sides.
2. On the vehicle underside, check whether water emerges from the
condensation water drains. If no water emerges, the hose is blocked. In this
case, reposition the hose correctly to ensure free passage or replace the
hose if it is damaged.
Invoice the damage with reference to the appropriate damage code..
Symptoms
Work units
-----------------------------------------------------Page
1-----------------------------------------------------
Mercedes Benz Diagnostic and Repair Information ,Wiring Diagrams. DTC. TSB. Types: TSB, DTC, Wiring Diagrams, OEM Procedures. Trusted by more than 400,000 technicians. OEM accurate fix for faster repairs. Repair Procedures and Labor Times. Factory Auto Repair info. Request A Demo Today. Factory-Correct Diagrams. Factory Part Numbers. Maintenance Schedules. Repair Procedures. Labor Times. Types: TSB, DTC.Mercedes,Mercedes,Benz,Mercedes-Benz UK,A,Class,B,Class,C,Class,E,Class,CLA,CLS,G,Class,GLA,A
Saturday, February 13, 2016
Computers/Controls - Malfunctions Of Various Power/Control Unit Mercedes Benz C 63 AMG Sedan (204.077) V8-6.3L (156.985)
Popular Posts
-
D138 The message from the auxiliary oil pump is not available on the CAN bus. Possible cause: M42 (Electric transmission oil ...
-
P179A77 The redundancy system for DIRECT SELECT has a malfunction. The commanded position cannot be reached. Possible cause: A80 (Inte...
-
$369.96 End Date: Sunday Jul-7-2019 10:07:39 PDT Buy It Now for only: $369.96 Buy It Now | Add to watch list
-
$250.95 End Date: Wednesday Jul-24-2019 15:08:29 PDT Buy It Now for only: $250.95 Buy It Now | Add to watch list
-
Okay, these are OBD-II trouble codes related specifically to issues with the **Downstream Oxygen Sensors** in your vehicle's exhaust sys...
-
P2505 Relay 'Circuit 87' ( Engine ) (P2505) Possible cause: N3/10 (MESFI [ME] control unit) K40/4kK (Engine electronics an...
-
P0117 B11/4 (Coolant temperature sensor) : Short circuit to ground (P0117) Possible cause: B11/4 (Coolant temperature sensor) R48 (...
Popular Posts
-
P179D The redundancy system for DIRECT SELECT was activated. There is a signal above the permissible limit value.2010 Mercedes Benz E 63 A...
-
P2505 Relay 'Circuit 87' ( Engine ) (P2505) Possible cause: N3/10 (MESFI [ME] control unit) K40/4kK (Engine electronics an...
-
C426 Start enable 'Drive authorization system' not issued. Possible cause: Engine management Affected functions: ...
-
Misfiring of cylinder 4 : Damages TWC (P0304) Misfiring of cylinder 4 : Damages TWC (P0304) Possible cause: Combustion misfirings Aff...
-
Part 1 One or more messages from control unit N80 (Steering column module) are not available on the CAN bus. Possible cause: Ch...
-
2010 Mercedes Benz Truck GL 350 BLUETEC (164.825) V6-3.0L DSL Turbo (642.820) Vehicle: All Technical Service Bulletins COMAND(R) - 'Dr...
-
2010 Mercedes Benz C 63 AMG Sedan (204.077) V8-6.3L (156.985) Vehicle: Customer Interest ABS/TCS - ABS Lamp ON/Codes 5603/5410 Set Y...
-
P179A77 The redundancy system for DIRECT SELECT has a malfunction. The commanded position cannot be reached. Possible cause: A80 (Inte...
-
D138 The message from the auxiliary oil pump is not available on the CAN bus. Possible cause: M42 (Electric transmission oil ...
-
P0108 B28 (Pressure sensor) : Short circuit to positive or open circuit (P0108) Possible cause: B28 (Pressure sensor) Affected functi...
Popular Posts
-
P179D The redundancy system for DIRECT SELECT was activated. There is a signal above the permissible limit value.2010 Mercedes Benz E 63 A...
-
D138 The message from the auxiliary oil pump is not available on the CAN bus. Possible cause: M42 (Electric transmission oil ...
-
Vehicle: All Technical Service Bulletins Diesel Engine - Crackling/Ticking Noise At Idle Engine makes intermittent knocking noise, ticking...
-
BMW (Benz-Wesbach) is a well-known and respected luxury brand in the European automotive market, particularly for sports cars like the M5. ...
-
P179A77 The redundancy system for DIRECT SELECT has a malfunction. The commanded position cannot be reached. Possible cause: A80 (Inte...
-
The Dremel 4300-9/64 is a versatile corded rotary tool kit designed for a wide range of applications, making it an excellent choice for DI...
-
Mercedes-Benz Mercedes Benz OEM Parts Mercedes Benz OE Replacement Parts Technical Service Bulletin # LI83-30_P-05363...
-
P179C09 Control unit 'DIRECT SELECT' has a malfunction. There is a component fault. Possible cause: A80 (Intelligent servo mod...
-
Okay, so I need to figure out the financial results for Tesla's second quarter of 2025 based on the information provided. Let me start...