Forward-facing 
Convertible seat 1 Adjust the seat. When using the front passenger seat If installing the child restraint system to the front passenger seat is unavoidable, refer to P.52for the front passenger seat adjustment. When using the rear seat If there is a gap between the child seat and the seatback, adjust the seatback angle until good contact is achieved. 2 Remove the head restraint if it interferes with your child restraint system. (P.152) If the head restraint cannot be removed, raise it to the uppermost position. 3 Place the child restraint system on the seat facing the front of the vehicle. 4 Run the seat belt through the child restraint system and insert the plate into the buckle. Make sure that the belt is not twisted. 5 Fully extend the shoulder belt and allow it to retract to put it in lock 56 1-2. Child safety mode. In lock mode, the belt cannot be extended. 6 While pushing the child restraint system into the rear seat, allow the shoulder belt to retract until the child restraint system is securely in place. After the shoulder belt has retracted to a point where there is no slack in the belt, pull the belt to check that it cannot be extended. 7 If the child restraint has a top tether strap, follow the child restraint manufacturer’s operation manual regarding the installation, using the top tether strap to latch onto the top tether strap anchor. (P.65) 8 After installing the child restraint system, rock it back and forth to ensure that it is installed securely
Convertible seat 1 Adjust the seat. When using the front passenger seat If installing the child restraint system to the front passenger seat is unavoidable, refer to P.52for the front passenger seat adjustment. When using the rear seat If there is a gap between the child seat and the seatback, adjust the seatback angle until good contact is achieved. 2 Remove the head restraint if it interferes with your child restraint system. (P.152) If the head restraint cannot be removed, raise it to the uppermost position. 3 Place the child restraint system on the seat facing the front of the vehicle. 4 Run the seat belt through the child restraint system and insert the plate into the buckle. Make sure that the belt is not twisted. 5 Fully extend the shoulder belt and allow it to retract to put it in lock 56 1-2. Child safety mode. In lock mode, the belt cannot be extended. 6 While pushing the child restraint system into the rear seat, allow the shoulder belt to retract until the child restraint system is securely in place. After the shoulder belt has retracted to a point where there is no slack in the belt, pull the belt to check that it cannot be extended. 7 If the child restraint has a top tether strap, follow the child restraint manufacturer’s operation manual regarding the installation, using the top tether strap to latch onto the top tether strap anchor. (P.65) 8 After installing the child restraint system, rock it back and forth to ensure that it is installed securely
No comments:
Post a Comment