Sunday, March 6, 2022

2010 Cadillac Truck SRX FWD V6-3.0L Page 1132

2010 Cadillac Truck SRX FWD V6-3.0L Page 1132



supplies 5 V to the IAT signal circuit, and a ground for the IAT low reference circuit.



Conditions for Running the DTC



P0112



* The engine run time is greater than 1 s.



* The DTC runs continuously when the above conditions are met.



P0113



* The engine run time is greater than 1 s.



* The DTC runs continuously when the above conditions are met.



P0114



* The ignition is ON or the engine is running.



* This DTC runs continuously within the enabling conditions.



Conditions for Setting the DTC



P0112



The ECM detects that the IAT sensor signal is warmer than 149掳C (300掳F) for greater than 7 s.



P0113



The ECM detects that the IAT sensor signal is colder than -60掳C (-76掳F) for greater than 7 s.



P0114



The ECM detects that the IAT sensor signal is intermittent or has abruptly changed for greater than 4 s.



Action Taken When the DTC Sets



* DTCs P0112, P0113, and P0114 are Type B DTCs.



* The ECM commands the cooling fans ON.



Conditions for Clearing the DTC



DTCs P0112, P0113, and P0114 are Type B DTCs.



Diagnostic Aids



* Depending on the ambient temperature, an IAT sensor signal circuit or low reference circuit that is shorted to the MAF sensor signal circuit



can cause a DTC P0113 and/or P0114 to set. This condition causes a rapid fluctuation in the IAT Sensor parameter.



* An IAT sensor signal circuit that is shorted to the MAF sensor ignition circuit can cause a DTC P0113 and/or P0114 to set.



* A MAF sensor ground circuit that is open will cause a DTC P0113 and/or a DTC P0114 to set.



Reference Information



Schematic Reference



Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls Schematics



(LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



DTC Type Reference



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)

No comments:

Post a Comment