2010 Cadillac Truck SRX FWD V6-3.0L Page 1702

2010 Cadillac Truck SRX FWD V6-3.0L Page 1702

(DTC) Type Definitions)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

1. Verify the transmission fluid level, color and odor is correct.

2. Operate the vehicle to induce a shift from fifth to sixth gear while observing the following scan tool parameters. The scan tool parameters has

to change the proper value referring to the current gear, compare the proper values with: Transmission System Description and Operation

(M36 and MXE) (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and Operation/AF40-6 - Automatic

Transmission/Transmission System Description and Operation (M36 and MXE)). Perform this action 2 times.

* Clutch Pressure Control Solenoid Valve 1 Current

* Clutch Pressure Control Solenoid Valve 2 Current

* Clutch Pressure Control Solenoid Valve 3 Current

* Brake Band Pressure Control Solenoid Valve Current

* Shift Solenoid Valve 1

* Shift Solenoid Valve 2

瀚慖f the scan tool parameter does not change the proper value and no other DTCs than P0729, P0731, P0732, P0733, P0734, P0735, P0736,

P0780, P1731 are set, go to Circuit/System Testing.

瀚慖f any other DTC is set, diagnose that DTC first.

Circuit/System Testing

Dynamic Test

1. Perform the line pressure check. Refer to Line Pressure Check (See: Transmission and Drivetrain/Automatic

Transmission/Transaxle/Testing and Inspection/Symptom Related Diagnostic Procedures/AF40-6 - Automatic Transmission/Line Pressure

Check).

2. Perform the transmission fluid check. Refer to Transmission Fluid Level and Condition Check (See: Transmission and Drivetrain/Automatic

Transmission/Transaxle/Testing and Inspection/Symptom Related Diagnostic Procedures/AF40-6 - Automatic Transmission/Transmission

Fluid Level and Condition Check).

3. If all circuits test normal, replace the K71 Transmission Control Module. Verify the DTC does not reset.

瀚慖f the DTC resets replace the control valve body.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Control valve body replacement-Refer to Control Valve Body Replacement (See: Transmission and Drivetrain/Automatic

Transmission/Transaxle/Valve Body/Service and Repair/AF40-6 - Automatic Transmission/Control Valve Body Replacement) for

replacement, setup, and programming.

* TCM-Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for replacement, setup, and

programming.

* Perform the Transmission Adaptive Functions (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and

Operation/AF40-6 - Automatic Transmission/Transmission Adaptive Functions).

P0733

DTC P0733

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC P0733

- 3rd Gear Ratio Incorrect

Diagnostic Fault Information