2010 Cadillac Truck SRX FWD V6-3.0L Technical Service Bulletin # 10-03-16-001 Date: 100719

2010 Cadillac Truck SRX FWD V6-3.0L Technical Service Bulletin # 10-03-16-001 Date: 100719

TPMS System - Service And Re-Learning Sensor IDs

INFORMATION

Bulletin No.: 10-03-16-001

Date: July 19, 2010

Subject: TPMS System Service and Re-Learning Sensor IDs

Models:

2011 and Prior GM Passenger Cars and Light Duty Trucks

2010 and Prior HUMMER H2

2009 and Prior HUMMER H3

2010 and Prior Saturn Models

2009 and Prior Saab 9-7X

with Wheel-Mounted Tire Pressure Sensors

In the event that the spare tire, which is normally not equipped with a tire pressure monitor (TPM) sensor, is installed in place of one of the road

tires and the vehicle is driven above 40 km/h (25 mph) for 20 minutes or more, the TPM indicator icon on the instrument panel cluster (IPC) will

flash for approximately one minute and then remain on steady each time the ignition is turned ON, indicating a diagnostic trouble code (DTC) has

been set.

The driver information center (DIC), if equipped, will also display a SERVICE TIRE MONITOR type message. When the road tire is repaired and

reinstalled in the original location, the TPM indicator icon illumination and DIC message may remain displayed until the DTC is cleared.

To ensure that the TPM indicator and the DIC message are cleared after service, it is necessary to clear any TPM DTCs using a scan tool. If a scan

tool is unavailable, performing the TPM relearn procedure using a TPM diagnostic tool will provide the same results.

It is advised to perform the relearn procedure away from other vehicles to prevent picking up a stray sensor signal. If one or more of the TPM

sensors are missing or damaged and have been replaced, then the relearn procedure must be performed.